Lightolier IS:7586 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

READ AND UNDERSTAND ALL TRACK, CONNECTOR, FEED-IN-KITS, AND ACCESSORY INSTRUCTION SHEET NO.
INSTRUCTION SHEETS BEFORE INSTALLING ANY TRACK ITEM.
This fixture is intended for installation in accordance with the National Electrical Code and local or Federal
code specifications. To assure full compliance with codes and regulations, check with your local electrical IS:7586
inspector before installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
B1197 Page 1 of 2

ملخص المحتوى في الصفحة رقم 2

INSTRUCTION SHEET NO. Installation Instructions for Stem Mounting Kit ™ Track Systems Only. for use with Lytespan and ProSpec IS:7586 B1197 Page 2 of 2 B. MOUNTING TRACK ONTO STEMS Center Barrier Track Rib 1. Loosen Screws on Track Clamps. In the stem used for power feed, Wireway Cover the Track Clamps must be positioned as shown in Fig. 2. Place Track Ribs (Fig. 4) between Track Clamps and side track into position. Make sure Bead (Basic and Advent only) (Fig. 4) of Track Units are in line with