Chamberlain LSIA دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

®
Model LSIA & LSIS
Wireless Portable Intercom - Extreme Range
Overview
Channel Select Button: Press the
The Intercom has up to a 1000' range and allows
Channel Select button to set
multiple simultaneous conversations, using a
intercom to one of four secure
900 Mhz secure digital radio link. The intercoms form
channels or the paging channel.
an exclusive network and respond only to other
The default channel for the
intercoms in the network.
intercom is the paging channel
where all four channel

ملخص المحتوى في الصفحة رقم 2

Assemble Intercom INTERCOM LEARN MODE Press the Learn Step 1 button until a OR OR beep is heard. Press and hold both buttons for 5 seconds. Each intercom will emit a tone when programmed into network. Repeat for any additional intercoms. Add to an Existing Network Install 4 AA Alkaline batteries (not provided). (Lithium batteries recommended for colder environments.) Step 2 Press the Learn button on the new intercom until a beep is heard. Within 10 seconds put any networked intercom into Learn

ملخص المحتوى في الصفحة رقم 3

Troubleshooting Intercom does not function. Need to clear intercom’s memory. Check batteries in intercom. If using an AC Adapter Press and hold Learn button, an initial beep will be ensure that it is plugged in. heard. Continue to hold until a second beep is heard Ensure intercom is connected to a network. (about 15 seconds). Ensure other intercoms are not See Programming Intercom. activated during this time. Intercoms in the network that Ensure that intercoms are on the same channel. See are on

ملخص المحتوى في الصفحة رقم 4

FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 www.chamberlain-DIY.com NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference