Blue Sea Systems PN 8261 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

WARNING
Marine Electrical Products
It is not possible within the scope of these instructions to fully acquaint
DC Power Distribution Panel
the installer with all the knowledge of electrical systems that may be
PN 8261 8 Position Water Resistant
necessary to correctly install this product. If the installer is not
knowledgeable in electrical systems we recommend that an electrical
PN 8262 4 Position Water Resistant
professional be retained to make the installation.
Panel Specifi cations

ملخص المحتوى في الصفحة رقم 2

Installation It is recommended that the positive feed wire be sized for the full panel 1. Disconnect all AC and DC power capacity, which, in most cases, will require at least 8 AWG wire, Before starting, disconnect the main positive cable from all batteries to assuming a 10 foot wire run between the panel and the batteries in eliminate the possibility of a short circuit while installing the distribution 12 volt systems. Refer to the Wire Sizing Chart for other situations. pan