Havis-Shields Docking Station DS-PAN-103 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

8 8 8 8 8 8 6 6 6 6 6 6 5 5 5 5 5 5 4 4 4 4 4 4 2 2 2 2 2 2 1 1 1 1 1 1
7 7 7 7 7 7 3 3 3 3 3 3
INSTALLATION INSTRUCTIONS:
1. REMOVE THE 1/4-20 X 5/8" BHCS HOLDING THE MOUNTING
BRACKET TO THE REST OF THE DOCKING STATION (THE SCREWS
IN THE PLASTIC SIDE-MEMBERS ON EACH SIDE OF THE DOCK).
PULL MOUNTING BRACKET OFF OF DOCKING STATION.
D D D D D D
D D D D D D
2. SET MOUNTING BRACKET ON TOP OF DESIRED SURFACE SO
THAT 3 OF THE HOLES ON THE MOUNTING BRACKET LINE UP WITH
3 TAPPED HOLES OF THE M

ملخص المحتوى في الصفحة رقم 2

8 8 8 8 8 8 6 6 6 6 6 6 5 5 5 5 5 5 4 4 4 4 4 4 2 2 2 2 2 2 1 1 1 1 1 1 7 7 7 7 7 7 3 3 3 3 3 3 INSTALLATION INSTRUCTIONS: STRAIN RELIEF NOTE: IT IS VERY IMPORTANT TO STRAIN RELIEF ALL CABLES LOCATIONS CONNECTED TO THE DOCKING STATION. D D D D D D D D D D D D 1. IF IT IS NECESSARY TO STRAIN-RELIEVE WIRES/CABLES, INSERT ZIP TIE/PUSH PIN FROM HARDWARE KIT INTO ANY OF THE THREE STRAIN RELIEF HOLES ON THE BOTTOM SIDE OF THE DOCK, AS SHOWN. LOOP AND TIGHTEN ZIP TIE AROUND WIRES/CABLES, AS REQ