ملخص المحتوى في الصفحة رقم 1
Operator’s Manual
SERIES 8000
COMPACT TRACTOR
MODEL 8354
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
CUB CADET LLC P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 [www.cubcadet.com]
PRINTED IN U.S.A. FORM NO. 769-01008
ECO
(12/03)
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS TO THE OWNER .................................................................................................................... 2 CALLING SERVICE INFORMATION ...................................................................................... 2 RECORDING MODEL AND SERIAL NUMBER INFORMATION ........................................... 3 IMPORTANT SAFE OPERATION PRACTICES ..................................................................... 4 SAFETY LABELS ....................
ملخص المحتوى في الصفحة رقم 3
RECORDING MODEL AND SERIAL NUMBER INFORMATION Product identification plates are provided for major components of your tractor. The numbers on these plates are important if your tractor should require dealer service, or if you need additional information on your tractor. Prior to using your tractor for the first time, record the numbers from the identification plates in the appropriate spaces provided below. The tractor model plate is located on the transmission housing on the left side of the
ملخص المحتوى في الصفحة رقم 4
IMPORTANT SAFE OPERATION PRACTICES WARNING: THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY OF YOURSELF AND OTHERS. READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE YOUR UNIT. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. WHEN YOU SEE THIS SYMBOL, HEED ITS WARNING. WARNING: The engine exhaust, some of its constituents, and certain vehicle components contain or em
ملخص المحتوى في الصفحة رقم 5
Before starting the engine, sit in the seat, Never operate the machine while under the disengage the clutch, and place the shift levers influence of alcohol or drugs, or while fatigued. in the neutral position. When working in cooperation with others, let them know in advance what you are doing. Use the ROPS (Roll Over Protective Structure) and seat belt for safe operation. Overturning Always sit in the tractor seat when starting the the tractor without a ROPS, or with a ROPS engine or
ملخص المحتوى في الصفحة رقم 6
Use the 3-point hitch only with equipment Never try to get on or off a moving tractor. designed for 3-point hitch usage. Never park the tractor on a steep incline. Do not operate near embankments, ditches, holes, or other terrain features which may col- lapse under the tractor’s weight. The tractor could suddenly turn over if a wheel goes over the edge of a cliff or ditch, or if an edge caves in. Driving forward out of a ditch or mired condi- tion, or up a steep slope, increases the ri
ملخص المحتوى في الصفحة رقم 7
Keep all movement on the slopes slow and Always slow the tractor down before turning. gradual. Do not make sudden changes in Turning at high speed may tip the tractor over. speed or direction. Rapid engagement or braking could cause the front of the machine to lift and rapidly flip over backwards which could cause serious injury. To avoid upsets, drive the tractor with care and at a safe speed. Use extra caution when operating over rough ground, when crossing ditches or slopes, and when tu
ملخص المحتوى في الصفحة رقم 8
Replace fuel cap securely and wipe off any 4. OPERATING THE PTO spilled fuel before starting the engine as it may Disengage the PTO, stop the engine, and wait cause a fire or explosion. until all moving components have completely Do not smoke when working around the battery stopped before dismounting the tractor and or when refueling. Keep all sparks and flames connecting, disconnecting, adjusting, cleaning, away from the battery and fuel tank. The or servicing any PTO driven equipment. b
ملخص المحتوى في الصفحة رقم 9
Disconnect negative cable from battery before Engine components become hot during working on or near electrical components. operation and can cause a burn. Allow to cool down before touching. To reduce fire hazard, keep the tractor free of Before "jump starting" a dead battery, read and any debris build-up. Clean up oil or fuel spillage. follow all of the instructions. Before cleaning, repairing or inspecting, make Do not attempt to mount a tire on the rim. This certain all moving pa
ملخص المحتوى في الصفحة رقم 10
SAFETY LABELS 1 2 4 3 7 6 5 1. DD-T2325-50512 3. DD-T2445-50724 4. DD-T2241-50702 2. DD-T2325-50743 10
ملخص المحتوى في الصفحة رقم 11
SAFETY LABELS (Cont.) 5. DD-T4625-52361 7. DD-T4625-53191 6. DD-T4625-52351 11
ملخص المحتوى في الصفحة رقم 12
SECTION 1: CONTROLS AND FEATURES SWITCHES AND DASH MOUNTED CONTROLS J B H F I C D E A G Figure 1 A. Ignition Switch F. Steering Tilt Lock Lever B. Light Switch G. Parking Brake Lever C. Turn Signal Switch H. Forward/Reverse Shift Lever D. Hazard Lamp Switch I. Hand Throttle Lever E. PTO Switch J. Instrument Panel A. Ignition Switch NOTE: The safety circuit will prevent the starter from turning if the clutch pedal is not depressed. NOTE: To prevent accidental starting and/or battery discharge,
ملخص المحتوى في الصفحة رقم 13
B. Light Switch Turn the light switch one click clockwise to illuminate the low beam headlights and the taillights. TILT LOCK HAZARD LEVER LAMP Turn the light switch one more click clockwise to SWITCH illuminate the high beam headlights. See Figure 3. Manual Auto. High Low Beam Beam PTO SWITCH Figure 4 F. Steering Tilt Lock Lever LIGHT TURN SIGNAL SWITCH Use this lever to lock the steering wheel in the tilt SWITCH position selected by the operator. See Figure 4. Figure 3 To reposition the st
ملخص المحتوى في الصفحة رقم 14
I. Hand Throttle Lever To set the parking brake proceed as follows: Lock the right and left brake pedals together When the hand throttle is pushed forward, the engine using the brake lock. Refer to Brake Lock in speed will increase. When pulled rearward, the Floorboard and Fender Mounted Controls later engine speed will decrease. in this section. Fully depress and hold the brake pedals. Fast Pull the brake lock lever upward and hold while while releasing the brake pedals. If properly engag
ملخص المحتوى في الصفحة رقم 15
4. Fuel Gauge - Indicates the volume of fuel in the PTO Mark fuel tank. 5. PTO Indicator - Illuminates when the PTO is engaged. 6. Coolant Level Lamp - Illuminates if the engine coolant level falls below a prescribed level. Stop the tractor and refill the cooling system. 7. Fuel Tank Level Warning Lamp - Illuminates when the fuel level is low. TACHOMETER HOURMETER 8. Engine Oil Pressure Warning Lamp - Illuminates when the ignition switch is turned on to assure Figure 9 the light is functioning
ملخص المحتوى في الصفحة رقم 16
FLOOR BOARD AND FENDER MOUNTED CONTROLS B B A C F D E A. Clutch Pedal D. Main Shift Lever B. Brake Pedals E. Hi-Lo Range Shift Lever C. Foot Throttle F. Auxiliary Hydraulics Lever Figure 11 A. Clutch Pedal WARNING: Always lock the brake pedals together before driving the tractor on When the clutch pedal is fully depressed, the tractor’s roadways or at high transport speeds. drive clutch is disengaged. Fully and rapidly depress Engaging only one brake under these the clutch pedal before shiftin
ملخص المحتوى في الصفحة رقم 17
C. Foot Throttle HI-LO RANGE SHIFTER The foot throttle is interlocked with the hand throttle. Low Range Depressing the foot throttle increases the engine speed. Full engine speed control can be obtained with the foot throttle if the hand throttle is in the full rearward (slow) position. The foot throttle may also be Neutral used to temporarily increase the engine speed above the hand throttle setting. D. Main Shift Lever High Range WARNING: Never shift the main shift lever without first disengag
ملخص المحتوى في الصفحة رقم 18
Use these control levers to control the working depth Differential Lock Pedal and pull of implements attached to the three point Located at the rear of the right floor board, the differ- hitch as follows: ential lock is used to gain additional traction when operating the tractor on wet or loose soil. When the Using Position Control — This will control the pedal is depressed the rear wheels of the tractor are working depth of 3-point implements regardless prevented from rotating independently o
ملخص المحتوى في الصفحة رقم 19
Turn the PTO switch to the manual position. Seat Adjustment Lever The seat adjustment lever is located beneath the left Pull the lever upward to engage the Mid PTO. side of the seat. This lever is used to adjust the seat Push the lever down to disengage the Mid PTO. forward or backward to the desired operating position. WARNING: To avoid possible personal See Figure 19. injury or damage to the tractor, make sure the Mid PTO is disengaged (lever down) when not in use. Engage Disengage MID P
ملخص المحتوى في الصفحة رقم 20
SECTION 2: OPERATION ROLLOVER PROTECTIVE STRUCTURE (ROPS) FUELING THE TRACTOR This tractor is equipped with a foldable Rollover Fill the fuel tank with only clean, fresh, diesel fuel. To Protection Structure (ROPS) and seat belts. When ensure the freshness of the fuel, purchase fuel in a used together they are effective in reducing injuries to quantity that can be used within 30 days. the operator in the event of an accidental tractor NOTE: DO NOT USE KEROSENE OR GASOLINE in rollover. The safet
