Ferris Industries Derby 1846197 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Derby Stallion Oil Cooler Kit
Installation
Part No. 1846197
For all Derby Stallion ZT2354 mowers
Instructions
This kit is for installing oil coolers to the
1 2
3
hydraulic system. This kit should be installed
when using the Triple Bagger Grass
Collection System.
Kit Contents:
5
Ref Part No. Qty. Description
1 22467 2 Oil Cooler
6
2 1846152 1 Mount Bracket-Left
3 1846153 1 Mount Bracket-Right 7
4 1846154 1 Oil Cooler Mount
5 22106 2 3/8” Hose Fitting
6 21164 4 Hose Clamp
4
7 25299 8 Bolt, 1/4-20

ملخص المحتوى في الصفحة رقم 2

Installation Instructions 1846197 7. Block the front wheels and jack up the rear of the machine and set on jack stands or wooden blocks. Remove the left drive tire. This will allow for easier access to the left hand pump. 8. Remove the left return hose and loosen the jam nut on the fitting on the pump. Rotate the fitting towards the rear of the machine and point it slightly upwards (see Figure 2). Tighten the jam nut. 9. Install the 25” hose assembly to the fitting on the pump and tighten. Leave

ملخص المحتوى في الصفحة رقم 3

Installation Instructions 1846197 19. Refill the oil reservoir to the “MAX OIL LEVEL HOT” line. Use either Mobil 1, 15W-50 synthetic oil or Castrol Syntec 5W-50 oil. DO NOT use conventional oils. Make sure area around the reservoir is free of dust, dirt, or other debris. 20. Reinstall the left drive tire and remove the jack stands. Lower the seat plate. 21. Make sure the parking brake is engaged, the control handles locked in the “NEUTRAL” position and the PTO switch is off. Reconnect the spark