Snapper 1694947 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Lift Lever Kit
Installation
Mfg. No. 1694947
For Broadmoor / 200 / 1600 / 2600 Series
Instructions
4
2
3
6
1
5
10
12
9
8
13
11
7
13
14
15
19
21
16
17
18
18
20
19
Used on single point pick-up
mowers only. See Figures 2 & 3
Kit Contents: 14 1725705A 1 BRACKET, Mounting
15 1960074 2 CLIP, Hair Pin
Ref Part No. Qty. Description
16 1960585 2 CAPSCREW, Hex Head,
1 1725959A 1 ROD & TUBE ASSEMBLY
5/16-18 x 1-3/4
2 1960033 1 CLIP, Hair Pin
17 1725957 2 PAD, Rubber
3 1723124 1 BUTTON, Red
18 2826149 3 C

ملخص المحتوى في الصفحة رقم 2

Installation Instructions Lift Lever Kit C C B B Mower Lift A Points Mower Lift Point A Figure 2. Typical Dual Point Pick-Up Figure 3. Typical Single Point Pick-Up A. Lift Shaft Assembly C. Lift Lever A. Bell Crank Assembly C. Lift Lever B. Lift Rod B. Lift Rod Note: Dual point pick-up mowers have the lift attached at two points on the mower deck. See Figure 2. Lift shaft assembly (A) is already installed on these tractors. Do not replace with lift shaft assembly provided in kit. Single po

ملخص المحتوى في الصفحة رقم 3

Lift Lever Kit Installation Instructions Install Lift Shaft Assembly A SINGLE POINT PICK-UP MODELS ONLY 1. Remove and retain spacer (E, Figure 6), bell crank B C assembly (F), washer (G), and nut (H). You may find installation easier to remove rod (C) and one cotter pin (A) and washer (B). 2. Remove and discard capscrew (D). D A B E G H F Figure 6. Rod & Bell Crank Removal A. Hair Pin E. Spacer B. Washer F. Bell Crank Assembly C. Rod G. Washer D. Capscrew H. Nut 3. Mount the lift shaft assembl

ملخص المحتوى في الصفحة رقم 4

Installation Instructions Lift Lever Kit Install Front Attachment Lift Lever & Rod A ALL MODELS B 1. Slide the lift lever assembly (A, Figure 8) on to the end of the shaft assembly and on to the edge of the B tractor. D 2. Secure to mounting bracket (D) using clevis pins (B) C and hair pin (C). End of Edge of Shaft Assembly Tractor Figure 8. Install Lift lever Assembly. A. Lift Lever Assembly C. Hair Pin B. Clevis Pin D. Mounting Bracket 3. Slide lift rod (A, Figure 9) into the bottom hole in