ملخص المحتوى في الصفحة رقم 1
PHANTOM Series PS2000
25 Watt VHF/FM
ITU Class D DSC Marine Transceiver
Owner's Manual
ITU-R Class D Commercial Grade remote mount VHF
Independent channel 70 receiver for continuous DSC watching
Capable of using up to two optional enhanced RAM+ type micro-
phones
30W PA/Fog signaling with bells and whistles
DSC position request, send functions and NMEA In/output for con-
nection to Standard Horizon plotters.
RAM+ to RAM+ intercom capability
Versatile user programmable scan, priorit
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS 1 GENERAL INFORMATION ...................................................................................... 4 2 PACKING LIST ........................................................................................................ 4 3 OPTIONS ................................................................................................................. 4 4 SAFETY / WARNING INFORMATION...................................................................... 5 5 FCC RADIO LICENSE
ملخص المحتوى في الصفحة رقم 3
TABLE OF CONTENTS 11 DIGITAL SELECTIVE CALLING ............................................................................ 32 11.1 GENERAL ...................................................................................................... 32 11.2 MARITIME MOBILE SERVICE IDENTITY (MMSI) ........................................ 33 11.2.1 What is an MMSI?................................................................................. 33 11.2.2 Programming the MMSI ...........................
ملخص المحتوى في الصفحة رقم 4
1 GENERAL INFORMATION The Phantom PS2000 is a revolutionary Commercial Grade remote control ITU-R Class D Marine VHF transceiver. The design allows the transceiver to be mounted in a protected area on vessels that may not have space to mount a full size VHF. The Phantom PS2000 is capable of using up to 2 enhanced full function RAM+ type microphones which are supplied seperately. When the optional RAM+ type microphone(s) are connected, the Phantom PS2000 allows full control of all VHF functions,
ملخص المحتوى في الصفحة رقم 5
4 SAFETY / WARNING INFORMATION This radio is restricted to occupational use, work related operations only where the radio operator must have the knowledge to control the exposure conditions of its passengers and bystanders by maintaining the minimum separation dis- tance of 0.6 m (2 feet). Failure to observe these restrictions will result in exceeding the FCC RF expo- sure limits. Antenna Installation: The antenna must be located at least 0.6 m (2 feet) away from passengers in order to comply w
ملخص المحتوى في الصفحة رقم 6
5 FCC RADIO LICENSE INFORMATION Vertex Standard radios comply with the Federal Communication Commission (FCC) requirements that regulate the Maritime Radio Service. STATION LICENSE An FCC ship station license is no longer required for any vessel traveling in U.S. waters (except Hawaii) which is under 20 meters in length. However, any vessel required to carry a marine radio on an international voyage, carrying a HF single side band radiotelephone or marine satellite terminal is required to have
ملخص المحتوى في الصفحة رقم 7
6 FCC NOTICE NOTICE Unauthorized changes or modifications to this equipment may void com- pliance with FCC Rules. Any change or modification must be approved in writing by Marine Division of Vertex Standard. NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful in- terference in a residential installation. This equipment generates, us
ملخص المحتوى في الصفحة رقم 8
7 GETTING STARTED 7.1 ABOUT VHF RADIO The radio frequencies used in the VHF marine band lie between 156 and 158 MHz with some shore stations available between 161 and 163 MHz. The ma- rine VHF band provides communications over distances that are essentially “line of sight” (VHF signals do not travel well through objects such as buildings, hills or trees). Actual transmission range depends much more on antenna type, gain and height than on the power output of the transmitter. On a fixed mount 2
ملخص المحتوى في الصفحة رقم 9
7.3 COAXIAL CABLE VHF antennas are connected to the transceiver by means of a coaxial cable – a shielded transmission line. Coaxial cable is specified by it’s diameter and construction. For runs less than 20 feet, RG-58/U, about 1/4 inch in diameter is a good choice. For runs over 20 feet but less than 50 feet, the larger RG-8X or RG-213/U should be used for cable runs over 50 feet RG-8X should be used. For installa- tion of the connector onto the coaxial cable refer to the figure below. Adapte
ملخص المحتوى في الصفحة رقم 10
8 INSTALLATION 8.1 LOCATION The radio can be mounted at any angle. Choose a mounting location that: • is far enough from any compass to avoid any deviation in compass read- ing due to the speaker magnet • allows connection to a power source and an antenna • It is recommended not to mount the antenna closer than three feet from the Phantom PS2000. Note: To insure the radio does not affect the compass or radios performance is not affected by the antenna location, temporarily connect the radio in
ملخص المحتوى في الصفحة رقم 11
2. Connect the red power wire to a 13.8 VDC ±20% power source. Connect the black power wire to a negative ground. 3. If an optional remote extension speaker is to be used, refer to next section for connections. 4. It is advisable to have a Certified Marine Technician check the power output and the standing wave ratio of the antenna after installation. ( ) 8.3 CMP25 RAM+ MICROPHONE S INSTALLATION NOTE The Phantom PS2000 is capable of connecting 2 RAM+ microphones to control all functions. 1. Conn
ملخص المحتوى في الصفحة رقم 12
RAM+ or External Speaker Selection By default the CMP25 RAM+ internal speaker is turned on, however using the RAM+ mic this speaker can be turned off so the external speaker can be used. [ ( ) ] 1. Press and hold down the CALL SET MENU key until “RADIO SETUP” menu appears. [ ( ) ] [ ] 2. Press the CALL SET MENU key, then press the or [ ] key to select “EXT SPK” menu. [ ( ) ] 3. Press the CALL SET MENU key. [ ] [ ] 4. Press the or key to turn the External Speaker “on.” [ ( ) ] 5. Press th
ملخص المحتوى في الصفحة رقم 13
8.5 CONNECTION OF GPS WITH NMEA OUTPUT Manufacturer/Model Wires PS2000 Manufacturer/Model Wires PS2000 Green Green Lowrance Portable Orange Blue STANDARD HORIZON Blue Gray Black (GND) Green Brown Blue Magellan Fixed Mount Gray Blue Furuno GP30, 36 White Blue Black (GND) Green Blue Green Magellan Portable Orange Blue Furuno GP1650, 1850 White Blue Black (GND) Green Black Green Northstar Yellow Blue Garmin Fixed Mounts Blue Blue Black (GND) Green Black (GND) Green Raytheon 420 Yellow Blue Garmin
ملخص المحتوى في الصفحة رقم 14
8.7 CHANGING THE GPS TIME You may select the time display between “Local time” and “UTC time” (GPS sends to Phantom PS2000). Time is displayed when GPS position (LAT/LON) is displayed by pressing the [NAV] key on the RAM+ mic. [ ( ) ] 1. On the RAM+ mic, press and hold down the CALL SET MENU key until “RARIO SETUP” menu appears. [ ( ) ] [ ] 2. Press the CALL SET MENU key, then press the or [ ] key to select “LOCAL TIME” menu. [ ( ) ] 3. Press the CALL SET MENU key. [ ] [ ] 4. Press the o
ملخص المحتوى في الصفحة رقم 15
8.8 CHANGING THE TIME OFFSET If you change the time display to “Local time” in the previous section, you need change the time offset to show the local time correctly in your area. [ ( ) ] 1. Press and hold down the CALL SET MENU key until “RADIO SETUP” menu appears. [ ( ) ] [ ] 2. Press the CALL SET MENU key, then press the or [ ] key to select “TIME” menu. [ ( ) ] 3. Press the CALL SET MENU key. [ ] [ ] 4. Press the or key to select time offset from UTC. See illustration below to find
ملخص المحتوى في الصفحة رقم 16
8.9 CHANGING COG TO TRUE OR MAGNETIC Allows customizing the NAV data showing GPS Course Over Ground (COG). Factory default is “True,” however, following the steps below the COG can be changed to “Magnetic.” [ ( ) ] 1. Press and hold down the CALL SET MENU key until “RADIO SETUP” menu appears. [ ( ) ] [ ] 2. Press the CALL SET MENU key, then press the or [ ] key to select “MAGNETIC” menu. [ ( ) ] 3. Press the CALL SET MENU key. [ ] [ ] 4. Press the or key to select “on (Magnetic)” or “of
ملخص المحتوى في الصفحة رقم 17
8.11 OPTIONAL MMB-84 FLUSH MOUNT INSTALLATION 1. To assist in flush mounting, a template has been included. Use this tem- plate to find the mounting location. 2. Use the template to mark the location where the rectangular hole is to be cut. Confirm the space behind the dash or panel is deep enough to accom- modate the transceiver (at least 15 cm deep). There should be at least 1 cm between the transceiver’s heatsink and any wiring, cables or structures. 3. Cut out the rectangular hole and inser
ملخص المحتوى في الصفحة رقم 18
9 CONTROLS AND INDICATORS NOTE This section defines each control, switch, and connector of the Phan- tom PS2000 Transceiver and CMP25 RAM+ Microphone. For detailed operating instructions refer to section “10. BASIC OPERATION.” 9.1 PHANTOM PS2000 TRANSCEIVER Page 18 Phantom PS2000
ملخص المحتوى في الصفحة رقم 19
PWR key NOTE The Phantom PS2000 is designed to be flush mounted or bracket mounted in a dry cool area when there is limited mounting areas. When it is bracket mounted the power switch on the Phantom PS2000 is not used instead use the PWR key located on the top of the RAM+ mic(s). Turns the transceiver on and off. To turn the transceiver on, press and hold this key until this switch illuminates orange. To turn it off, press and hold this key until the illumination turns off. When the power is tur
ملخص المحتوى في الصفحة رقم 20
MENU 9.2 CMP25 RAM+ MICROPHONE SQUELCH CONTROL (SQL) Activates the squelch adjusting mode. Press this key to activate the squelch [ ] [ ] adjusting mode. Press the or key to adjust the squelch. ( ) VOLUME KEY VOL Activates the volume adjusting MEM IC WX SCAN DW mode. CALL Press this key to activate the volume NAV 16 SET 9 [ ] [ ] adjusting mode. Press the or to adjust the volume. ( ) POWER SWITCH PWR Press and hold down this key to turn to the transceiver and RAM+ Mic on and off. ( ) PT
