Victorinox Night Vision II دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

BASIC OPERATING INSTRUCTIONS
NIGHT VISION II

ملخص المحتوى في الصفحة رقم 2

THREE HAND ANALOG QUARTZ NOTE: Refer to page 4 to determine what type of crown your timepiece has (pull-out or screw-down). SETTING THE DATE AND TIME A. Pull out the crown to position (2). B. Rotate the crown toward you until the date showing is the day before the desired setting. 1 2 3 C. Pull out the crown to position (3) and rotate toward you. When midnight is reached, the date will advance to the desired date. Crown Continue to turn the crown until the desired time is set. Remember, the dat

ملخص المحتوى في الصفحة رقم 3

NIGHT VISION II LED Light The Night Vision II makes use Functions of Light Emitting Diodes (LEDs) for its flashlight and soft dial lighting. LEDs last longer than conventional incandescent bulbs, and are more durable and energy-efficient. Please note that the battery life of the lighting functions is significantly reduced with greater use. To maximize battery Crown life, please turn lighting functions off when not in use. Luminous hands and markers are activated by external UV lighting. Push

ملخص المحتوى في الصفحة رقم 4

TIME AND DATE To set time and date please refer to instructions for Three Hand Analog Quartz. Lighting Functions – Night Vision II 1. Dial Illumination Mode One quick push of the pusher will activate the soft LED light for 5 seconds. The angle of the light directs it to reflect off the crystal for maximum visibility of 1. the dial and hands. 2. Extended Light Mode Two quick pushes of Pusher the pusher will activate the LED flashlight for 2 minutes. Light will automatically deactivate, or

ملخص المحتوى في الصفحة رقم 5

3. Signal Mode Three quick pushes of the pusher will cause the light to strobe for 2 minutes. To deactivate, press pusher once. 4. Intense Signal Mode Holding the pusher for 5 seconds will activate an intensified LED strobe that flashes continuously. Intense Signal Mode is brighter than normal Signal Mode flashing. To deactivate, press pusher for 5 seconds. 2. 5. Locator Mode Red LED locator beacon is Pusher positioned at the 6 o’clock marker and blinks once every 10 seconds. An easy way t

ملخص المحتوى في الصفحة رقم 6

Your Night Vision II timepiece has a built-in feature to protect battery consumption if the pusher used to operate the LED is accidentally pressed (for example in luggage or coat pocket, etc.). If the pusher is pressed for more than 30 consecutive seconds, the lighting feature will shut off automatically. Batteries for Light Function – Night Vision II The lighting modules of your Night Vision II timepiece operate off of a separate battery power source than the timepiece movement itself (1 batt

ملخص المحتوى في الصفحة رقم 7

BATTERY Worn Batteries should be replaced immediately. Substituting interchangeable batteries is not recommended. Battery change should be performed by a qualified technician who should also check the condition of the gaskets and the o-ring at the same time. Battery is not covered by the warranty.