Varimixer W150 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Motor Removal Instructions
Models W30-W150
PLEASE REFER TO THE DIAGRAM ON PAGE 2
1 REMOVE NUT (J) AND SHIM WASHERS (H)
2 PRY OFF FORK ASSEMBLY (X).
3 REMOVE SPECIAL V-BELT (A).
4 REMOVE TWO 17MM BOLTS (V)
5 REMOVE 4 BOLTS FROM MOTORPLATE (T).
6 ON OLDER MODEL MIXERS WITH SINGLE PHASE MOTORS,IT MAY BE NECESSARY

TO DISCONNECT THE START & RUN CAPACITORS FROM THE SIDE OF THE

MOTOR BEFORE LIFTING THE MOTOR OUT OF THE M

ملخص المحتوى في الصفحة رقم 2

Motor Removal Instructions Models W30-W150

ملخص المحتوى في الصفحة رقم 3

Motor Removal Instructions Models W30-W150 18 INSTALL SPECIAL V-BELT (A). 19 INSTALL FORK ASSEMBLY (X). 20 INSTALL WASHERS (G) (H) AND NUT (J).DO NOT TIGHTEN NUT. 21 START THE MIXER AND TIGHTEN THE NUT (J). DO NOT OVERTIGHTEN! 22 ON THE FRONT PULLEY SET,THE STUD (K) ON THE VARISPEED COLLAR (L) MUST BE PLACED INSIDE THE LOWER FORK (M),AND ON THE REAR PULLEY SET OUTSIDE THE FORK (N). 23 ADJUST THE SPEED BY TURNING THE THE STOP SCREWS (O) IN OR OUT. 24 THE STOP SCREWS (O) ON THE SPEED LEVER SHOU