American Audio XDM343 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

User Instructions
X D M - 3 4 3
PREAMP MIXER
Thank you for purchasing this American DJ® product. The XDM-343 is ready to be used,
there is no assembly required. Please read the following instructions before installing
or using your new unit. The XDM-343 has a 2 year limited warranty!
C A U T I O N ! - Keep this device away from rain and moisture!
Safety Instructions
Always plug in the power last. Make sure that the Power switch is set to the OFF position before connecting other devices
to the

ملخص المحتوى في الصفحة رقم 2

Operating Determinations When installing this mixer, please make sure that the device is not exposed to extreme heat, moisture or dust! There should not be any cables lying around. Doing so endangers you as well as others. Do not operate the mixer in extremely hot (more than 30˚C / 100˚F) or extremely cold (less than 5˚C / 40˚F) surroundings. Keep away from direct sunlight and heaters. Operate the mixer only after becoming familiar with its functions. Do not permit operation by persons not quali

ملخص المحتوى في الصفحة رقم 3

Functions 10 4 3 2 1 11 5 15 12 16 13 17 14 6 7 9 8 (1) POWER SWITCH (2)MASTER LEVEL / PFL DISPLAY - The upper display shows the level of the left and right master output. The lower display shows the level of the channel currently being cued (PFL LED on). (3) GAIN CONTROL - Used to set the level of the input signal. (4) BASS/MIDDLE/TREBLE CONTROL - Used to increase or decrease the LOW’s, MIDs, and HIs of the input signal. (5) PHONO / LINE I MIC SWITCH - Used to select the input to be sent to th

ملخص المحتوى في الصفحة رقم 4

Functions (Cont.) (12) CUE MIXING CONTROL - Selects the channel for monitoring. The monitor signal comes from Prefader. This means it will not be affected by the channel faders. You can monitor every channel individually and all possible combinations. Connect your headphones to the HEADPHONES jack (14). Turn the CUE MIXING CONTROL to CUE and select the desired channels with the PFL switches (7). When you turn the CUE MIXING CONTROL to PGM (PFL switches without function), you can cue the output s

ملخص المحتوى في الصفحة رقم 5

(28) MIC 2 JACK - Connect your microphone with 1/4 inch (6.3mm) jack plug here. The signals can be controlled via CHANNEL 2, if the PHONO / LINE / MIC switch (5) is set to MIC 2. (29) LINE 3 - PHONO 3 SELECTOR - Used to switch the CH-3 input jacks to line 3 or phono 3. Replacing the Crossfader Instructions for replacing the crossfader: • Disconnect from main power supply • Remove the fader knob. • Remove the two outer screws. • Take the fader out and unplug the connection cable. • Connect the ne