Fujitsu Siemens Computers Standard Jumper Cable / Network Cable without jumper Siemens S7 300 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Series HMI Connection Manual
Siemens S7 300 (ISO TCP)
HMI Factory Setting:
IP Address: 192.168.0.1
COM Port: 102
Control Area / Status Area: DBW0 / DBW20

Connection
Standard Jumper Cable / Network Cable without jumper (Auto-detected by HMI)

Definition of PLC Read/Write Address
a. Registers
Format
Type Read/Write Range Data Length Note
Word No.(n)
Bank No.(m)
IWn IW0 – IW65534 Word
Input Image
IDn ID0 – ID65532 Double Word
QWn QW0 – QW65534 Word
Output Image
QDn QD0 –

ملخص المحتوى في الصفحة رقم 2

Series HMI Connection Manual b. Contacts Format Word No.(n) Type Read/Write Range Note Bank No.(m) Bit No.(b) Input Image In.b I0.0 - I65535.7 Output Image Qn.b Q0.0 - Q65535.7 Internal Bits Mn.b M0.0 - M65535.7 Data Area DBm.DBXn.b DB1.DBX0.0 – DB255.DBX65535.7 DBXn.b DBX0.0 – DBX65535.7 Data Area (DB10) Vn.b V0.0 – V65535.7 NOTE 1) PLC needs to enable DB memory (DBm.DBWn 、DBm.DBDn 、DBm.D

ملخص المحتوى في الصفحة رقم 3

Series HMI Connection Manual 2 、 MD12 which Data Type is Byte and Data Length is Double Word ，when it used for one word Numeric Entry, it will occupy four addresses MB12,MB13,MB14 and MB15; But data only stored in MB14 and MB15. 3 、 IW3 which Data Type is Byte and Data Length is 1 Word , when it used for double word Numeric Entry, it will occupy for addresses IB3,IB4,IB5 and IB6 ，order from highest to lowest byte is IB5,IB6,IB3 和 IB4. V1.02 Revision January, 2012 205

ملخص المحتوى في الصفحة رقم 4

Series HMI Connection Manual Settings Screen Editor ： 1. HMI Ethernet Setting 206 V1.02 Revision January, 2012

ملخص المحتوى في الصفحة رقم 5

Series HMI Connection Manual 2. PLC Ethernet Setting Simatic (V5.4) ： 1. Right click on “CP343-1 Lean” module and select "Object Properties", on this page set up “IP address” and “Subnet mask” for CP343-1 Lean Module. Please be aware that the “IP address” setting must be the same as PLC Ethernet setting in Screen Editor and the “Subnet mask” setting must be the same as the HMI Ethernet setting in Screen Editor. 2. To add a new "Other station", right click on “Object Properties", add

ملخص المحتوى في الصفحة رقم 6

Series HMI Connection Manual 3. Right click on the CPU module and select "Insert New Connection", for “Connection Partner” select “Unspecified” and for “Type” select “TCP connection”. Then go to "Properties - TCP connection" >"Options", and set “Mode” to “Fetch passive”; please follows the restriction for “Address” setting, set “Address” to Local Port No. must be the same as PLC Ethernet setting in Screen Editor, to Partner’s IP must be the same as HMI Ethernet setting in Screen Editor,