Dialogic Media Board VFX/41JCT-LS دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

®
Note: The Dialogic software can correctly register Note: If these boards are operating in SCbus mode, CT
A. Set the Board ID Number
4. Install the Board
your boards for proper operation; however, due to Bus (H.100) termination is not required.
®
®
When you start Dialogic boards, each board is
variations among computer chassis, it is not possible for
The following instructions only apply to the boards at
Dialogic assigned a sequential number for identification and use
the software

ملخص المحتوى في الصفحة رقم 2

All contents of this document are furnished for informational use only and 3. Insert the board’s edge connector into the bus slot. 2. Attach the cable to the next board until all boards are Your application software or Dialogic software release are subject to change without notice and do not represent a commitment on 7. Complete Board Installation Use the slot’s board guides as you insert the board connected by the cable. may have special installation or configuration the part of Dialogic C