ملخص المحتوى في الصفحة رقم 1
8000/8600
Getting Started Guide
Revision Date: 11.27.2002
9032552-16
ملخص المحتوى في الصفحة رقم 2
ELECTRICAL HAZARD: Only qualified personnel should perform installation procedures. NOTICE Enterasys Networks reserves the right to make changes in specifications and other information contained in this document and its web site without prior notice. The reader should in all cases consult Enterasys Networks to determine whether any such changes have been made. The hardware, firmware, or software described in this document is subject to change without notice. IN NO EVENT SHALL ENTERASYS NETWORK
ملخص المحتوى في الصفحة رقم 3
FCC NOTICE This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against ha
ملخص المحتوى في الصفحة رقم 4
CLASS 1 LASER TRANSCEIVERS THE SINGLE MODE INTERFACE MODULES USE CLASS 1 LASER TRANSCEIVERS. READ THE FOLLOWING SAFETY INFORMATION BEFORE INSTALLING OR OPERATING THESE MODULES. The Class 1 laser transceivers use an optical feedback loop to maintain Class 1 operation limits. This control loop eliminates the need for maintenance checks or adjustments. The output is factory set, and does not allow any user adjustment. Class 1 Laser transceivers comply with the following safety standards: 21 C
ملخص المحتوى في الصفحة رقم 5
ENTERASYS NETWORKS, INC. PROGRAM LICENSE AGREEMENT BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT, CAREFULLY READ THIS LICENSE AGREEMENT. This document is an agreement (“Agreement”) between You, the end user, and Enterasys Networks, Inc. (“Enterasys”) that sets forth your rights and obligations with respect to the Enterasys software program (“Program”) in the package. The Program may be contained in firmware, chips or other media. UTILIZING THE ENCLOSED PRODUCT, YOU ARE AGREEING TO BECOME B
ملخص المحتوى في الصفحة رقم 6
6. EXCLUSION OF WARRANTY. Except as may be specifically provided by Enterasys in writing, Enterasys makes no warranty, expressed or implied, concerning the Program (including its documentation and media). ENTERASYS DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE SUPPLIED TO YOU BY ENTERASYS IN WRITING, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE PROGRAM, THE ACCOMPANYING WRITTEN MATERIALS,
ملخص المحتوى في الصفحة رقم 7
DECLARATION OF CONFORMITY Application of Council Directive(s): 89/336/EEC 73/23/EEC Manufacturer’s Name: Enterasys Networks, Inc. Manufacturer’s Address: 35 Industrial Way PO Box 5005 Rochester, NH 03866-5005 European Representative Address: Enterasys Networks Ltd. Nexus House, Newbury Business Park London Road, Newbury Berkshire RG14 2PZ, England Conformance to Directive(s)/Product Standards: EC Directive 89/336/EEC EC Directive 73/23/EEC EN 55022 EN 55024 EN 60950 EN 60825 Equipment Type/Envir
ملخص المحتوى في الصفحة رقم 8
vi Enterasys X-Pedition 8000/8600 Getting Started Guide
ملخص المحتوى في الصفحة رقم 9
Contents Notice ..................................................................................................................... ii About this Guide .................................................................................................. xi What’s New................................................................................................................................xi Who should Read this Guide?............................................................................
ملخص المحتوى في الصفحة رقم 10
Contents Appendix B: Hardware Components...............................................................105 SSR-ATM29-02 ..................................................................................................................... 106 SSR-CM2B-64, SSR-CM3-128, and SSR-CM4-256 ............................................................ 107 SSR-FDDI-02......................................................................................................................... 109 SSR-GLX39-02..
ملخص المحتوى في الصفحة رقم 11
About this Guide This guide provides a general overview of the 8-slot and 16-slot Enterasys Networks X-Pedition 8000 and X-Pedition 8600 hardware and software features. It provides procedures for installing the X-Pedition 8000 and X-Pedition 8600. For product information not available in this guide, see the manuals listed in Related Documentation on page xii. What’s New Changes to this manual include the addition of new and extended capabilities for the following: Line Cards on page 20 Contro
ملخص المحتوى في الصفحة رقم 12
Preface How to Use this Guide If you want to... See... Get an overview of the X-Pedition 8000 and Chapter 1, Features Overview X-Pedition 8600 software and hardware features Install the X-Pedition 8000 or X-Pedition 8600 Chapter 2, Hardware Installation hardware Install the X-Pedition 8000 or X-Pedition 8600 Chapter 3, Software Installation software, boot the software, and set up the unit and Setup Troubleshoot installation problems Appendix A, Troubleshooting Cabling and LED information Appen
ملخص المحتوى في الصفحة رقم 13
Chapter 1 Features Overview The 8-slot and 16-slot Enterasys Networks X-Pedition 8000 and X-Pedition 8600 provide non- blocking, wire-speed Layer-2 (switching), Layer-3 (routing) and Layer-4 (application) switching. This chapter provides a basic overview of the X-Pedition 8000 and X-Pedition 8600 software and hardware feature set. If you want to skip this information and install the X-Pedition now, see Chapter 2, Hardware Installation. If you want to boot the X-Pedition software and perf
ملخص المحتوى في الصفحة رقم 14
Specifications The following table lists the basic hardware and software specifications for the X-Pedition. Feature Specification Throughput 16-Gbps non-blocking swit ching fabric (X-Pedition 8000) 32-Gbps non-blocking switch ing fabric (X-Pedition 8600) Up to 30 million packets-per-sec ond routing throughput (X-Pedition 8600) Up to 15 million packets-per-sec ond routing throughput (X-Pedition 8000) Capacity Up to 250,000 routes Up to 2,000,000 Layer-4 appl ication flows (X-Pedition
ملخص المحتوى في الصفحة رقم 15
Specifications Feature Specification Port mirroring Traffic to the control module Traffic from specific ports Traffic to specific chassis slots (line cards) Hot swapping Line cards Control module (when re dundant control module is installed and online) Switching Fabric M odules (X-Pedition 8600 only—when redundant switch fabric is installed and online) Power Supply (when redundant supply is installed and online) Load balancing/ Enterasys SmartTRUNK support sharing Load Sharing
ملخص المحتوى في الصفحة رقم 16
Specifications TCP/UDP Services The following table lists some well-known TCP/UDP services provided by the X-Pedition. TCP Port UDP Port Description 23 Telnet 161 SNMP 67 BOOTP/DHCP Relay Agent 520 Routed 4 Enterasys X-Pedition 8000/8600 Getting Started Guide
ملخص المحتوى في الصفحة رقم 17
Features Features This section describes the following X-Pedition features: Address-based and flow-based bridging Port-based VLANs and protocol-based VLANs IP and IPX routing Layer-4 (application) switching Security Quality of Service (QoS) Statistics Management Bridging The X-Pedition provides the following types of wire-speed bridging: Address-based bridging – The X-Pedition performs this type of bridging by looking up the destination address in an L2 lookup table on the li
ملخص المحتوى في الصفحة رقم 18
Features Port and Protocol VLANs The X-Pedition supports the following types of Virtual LANs (VLANs): Port-based VLANs – A port-based VLAN is a set of ports that comprises a Layer-2 broadcast domain. The X-Pedition confines MAC-layer broadcasts to the ports in the VLAN on which the broadcast originates. X-Pedition ports outside the VLAN do not receive the broadcast. Protocol-based VLANs – A protocol-based VLAN is a named set of ports that comprises an IP or IPX broadcast domain. The X-Pe
ملخص المحتوى في الصفحة رقم 19
Features IP Routing The X-Pedition supports the following IP unicast routing protocols: RIP v1 and RIP v2 OSPF v2 BGP 2,3,4 IP interfaces do not use a specific routing protocol by default. When you configure an interface for routing, you also specify the routing protocol the interface will use. IP Multicast Routing The X-Pedition supports the following IP multicast routing protocols: IGMP DVMRP PIM-SM The X-Pedition does not use a specific IP Multicast routing protocol by default. Whe
ملخص المحتوى في الصفحة رقم 20
Features Layer-4 flows – The X-Pedition can store Layer-4 flows on each line card. A Layer-4 flow consists of the source and destination addresses in the IP or IPX packet combined with the TCP or UDP source and destination port number (for IP) or the source and destination socket (for IPX). You can therefore manage and control individual flows between hosts on an individual application basis. A single host can have many individual Layer-4 entries in the X-Pedition. For example, an IP host
