Psiber Data Systems Pinger Plus Network IP Tester دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

UPDATE PINGER SCREEN
The Pinger Plus firmware can be updated over the network as
new revisions are released. Notice of a new revision will be provided
on the Psiber web site (www.psiber.com). Download the new firmware
file, connect the Pinger Plus to the network, go to the Update Pinger TM
+ +
+ + +
P PINGER INGER P PLUS LUS
P P PINGER INGER INGER P P PLUS LUS LUS
Setup screen, press the Select function key and the unit will Link to the
network and enable the firmware update m

ملخص المحتوى في الصفحة رقم 2

PINGER IP SETUP SCREEN BOX CONTENTS The IP address for the Pinger Plus is input from this screen. The • Pinger Plus Network IP Tester • AC Adapter unit comes programmed with a default address of 192.168.1.42. • Four AA Alkaline Batteries • User Guide SUBNET MASK SETUP SCREEN BATTERY To Ping an IP address in a subnet different than the subnet of the The Pinger Plus operates on four AA Pinger Plus, requires that the Subnet Mask be entered and “ON” and the alkaline batteries. Remove the batte

ملخص المحتوى في الصفحة رقم 3

PORT ID SCREEN OPERATION Pressing the PortID function key in the Link Screen presents the To test a hub, switch, router or NIC connect a patch cable from the Port ID Screen. As soon as this screen appears, the Pinger begins RJ-45 port on the equipment to the RJ-45 jack on the Pinger Plus. transmitting a pattern of Link signals LINK SCREEN that will cause the hub,switch or NIC Turn on the Pinger Plus by pressing the “PWR” button. The unit Link LED to blink or stay on continu- scans the RJ-45 con

ملخص المحتوى في الصفحة رقم 4

Note: When the IP address of the device being PINGed is in the same DHCP SCREEN subnet/VLAN as the IP address of the Pinger, the Subnet Mask can be Pressing the DHCP function key in the Link Screen presents the “ON” or “OFF” and a Gateway IP address is not required. When the IP DHCP Screen and begins the DHCP client-server test. address is in a different subnet/VLAN, the Subnet Mask must be “ON” Note: The MAC Address of the Pinger with the mask entered and the IP address of the Gateway must be P