Spectra Watermakers EVO Series DGP-NE96 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

EVO Spectra
Entering EVO Programming Entering Spectra Programming
Sections Sections
1. Hold [0] key + [INSTALLER CODE] 1. Press the [ENTER] key
2. Enter section [953] (DGP-848) [4003] (EVO) 2. Enter the [INSTALLER CODE]
Enable Serial Port
Printer Module V1.1 3. Enter module’s 8-digit [SERIAL NUMBER] 3. Enter 3-digit [SECTION] you wish to program
4. Enter [SECTION] and enter the required [DATA] 4. Enter the required [DATA] Option [1]
APR-PRT3
The Printer Module can use the HyperTerminal® co

ملخص المحتوى في الصفحة رقم 2

1. See “LED Feedback” on page 1 2. 25-Pin Parallel Port: Connect the Printer Module’s 25-pin parallel port to any dot matrix printer. Note: The dot matrix printer must support a minimum of 80 columns. 3. 9-Pin Serial Port: Connect the Printer Module’s 9-Pin serial port to a dot matrix printer. Note: The dot matrix printer must support a minimum of 80 columns. 4. 9-pin Serial Port: Connect the Printer Module’s 9-pin serial port to a home automation module. 5. 9-pin Serial Port: Connect C-Bus to