ملخص المحتوى في الصفحة رقم 1
iPod2Car
Adapter
Instruction Manual
IPOD2CAR.COM
43C Rocklyn Ave
Lynbrook, NY 11563
Phone 516-887-8885 Fax 516-887-8881
Multi Technology Equipment LLC
v.1.3.A All Rights Reserved
ملخص المحتوى في الصفحة رقم 2
Table of Contents CHAPTER 1 Installation Preparation (All Vehicles) 1 Load/Unload Magazine 3 CHAPTER 2 Dip-Switch Overview (REQUIRED) 4 Acura 5 Audi 6 Ford (Ford, Lincoln, Mercury) 7-8 GM (Buick, Cadillac, Chevy, GMC, Oldsmobile, Pontiac, Saturn) 9-10 Chrysler (Jeep, Dodge, Plymouth, Eagle) 12 Honda 13 Toyota 14 Volkswagen 15 CHAPTER 3 Troubleshooting 16 Warranty/Warnings 17 FCC and Legal Information 18
ملخص المحتوى في الصفحة رقم 3
VEHICLE INSTALLATION Chapter Installation Preparation This chapter provides information required for the installation 1 of the IPOD2CAR ADAPTER, it must be read by all users. Thank you for purchasing the IPOD2CAR ADAPTER. Since the IPOD2CAR ADAPTER will works in many different vehicles the following steps must be taken to ensure the IPOD is set up correctly for the vehicle it is being installed in. Before Installation To prevent damage to your vehicle and the IPOD take the following
ملخص المحتوى في الصفحة رقم 4
VEHICLE INSTALLATION 3
ملخص المحتوى في الصفحة رقم 5
VEHICLE INSTALLATION Chapter 2 Vehicle Installation In this chapter you will learn how to install the IPOD2CAR ADAPTER in specific vehicles. The IPOD2CAR ADAPTER is what connects the IPOD to your vehicles factory car stereo. This IPOD2CAR ADAPTER, and to the specific cable needed for your car. Browse to the specific section for your vehicle to learn how to set up the IPOD2car and install in your vehicle. Below is an overview of all black box settings. Dip-Switch Overview The dip sw
ملخص المحتوى في الصفحة رقم 6
VEHICLE INSTALLATION Acura Before connecting any cables to the black box you must set the dip switch to the Chrysler New / Honda / Acura position. If you set the dip-switches after you have connected cables to the box, you must disconnect and reconnect them for the IPOD to operate. 1 2 3 4 5 6 7 8 SETTINGS ON OFF OFF ON OFF OFF OFF ON FOR ALL ACURAS § All Models (1992-2002) – Connector behind the radio, use the “Chrysler New” cable and the black box settings above. § TL 199
ملخص المحتوى في الصفحة رقم 7
VEHICLE INSTALLATION Audi Make sure you have your radio’s theft protection code before you attempt installation. When you reconnect power to the battery, you will need to enter this code. Information about the theft protection code can be found in your vehicle’s audio operation manual. Before connecting any cables to the black box you must set the dip switch to the Audi position. If you set the dip-switches after you have connected cables to the box, you must disconnect and reconnect t
ملخص المحتوى في الصفحة رقم 8
VEHICLE INSTALLATION Ford (Ford, Lincoln, Mercury) Before connecting any cables to the black box you must set the dip switch to the “Ford 1” position. If you set the dip-switches after you have connected cables to the box, you must disconnect and reconnect them for the IPOD2CAR to operate. *If you use “Ford 16 Pin”, “Ford 20 pin” and “Ford RCU cable”, make sure you connect the Yellow loose wire to Constant 12V+ and the Black loose wire to Ground or any part of the car chassis. *If you d
ملخص المحتوى في الصفحة رقم 9
VEHICLE INSTALLATION Model Year(s) IPOD Location and notes Model Year(s) IPOD Location and Notes Ford 16-Pin connector behind Radio. Continental 1998-2004 20-Pin connector behind Radio. Crown Victoria 1995-1997 Premium Audio System RCU (Rear Control Unit) in the LS 2000-2003 20-Pin connector behind Radio. trunk. Crown Victoria 1995-1997 JBL / Luxury System 16-Pin connector behind Radio. Crown Victoria 1998-2003 20-Pin connector behind Radio. Escape 2001-2004 20-Pin connector
ملخص المحتوى في الصفحة رقم 10
VEHICLE INSTALLATION GM (Buick, Cadillac, Chevy, GMC, Pontiac, Saturn) *PLEASE READ* *1995-1999 Radios with built in CD player (Except Corvette) are NOT compatible with the IPOD2CAR ADAPTER. *2000-2004 Radios with built in CD player ARE compatible. Separate OEM CD (1995-2000) must be disconnected to use the IPOD2CAR ADAPTER. 2003 – 2005: If XM mode is used, the you must not have GM factory original XM tuner installed. If installed you must unplug it for IPOD2CAR
ملخص المحتوى في الصفحة رقم 11
ملخص المحتوى في الصفحة رقم 12
ملخص المحتوى في الصفحة رقم 13
VEHICLE INSTALLATION Chrysler (Chrysler, Jeep, Dodge, Plymouth, Eagle) Make sure the IPOD2CAR ADAPTER is compatible with your vehicle, Check for “Disc ^” printed on preset button “1”. If you see it, it means that your radio can control the IPOD2CAR ADAPTER. Before connecting any cables you must set the dip switch box to the position listed for your vehicle. If you set the dip-switches after you have connected cables to the box, you must disconnect and reconnect them for the IPOD to oper
ملخص المحتوى في الصفحة رقم 14
VEHICLE INSTALLATION Honda – All Honda except Passport Before connecting any cables you must set the dip switch box to the position listed for your vehicle. If you set the dip-switches after you have connected cables to the box, you must disconnect and reconnect them for the IPOD to operate. Honda 1 2 3 4 5 6 7 8 SETTINGS ON OFF OFF ON OFF OFF OFF ON FOR HONDA Compatible with Honda 1992- 2004 except: Honda Passport 2003-2004 Accord ; 2003-2004 Element ; 2004 + Honda S200
ملخص المحتوى في الصفحة رقم 15
VEHICLE INSTALLATION Toyota / Scion / Izusu / Honda-Passport Before connecting any cables you must set the dip switch box to the position listed for your vehicle. If you set the dip-switches after you have connected cables to the box, you must disconnect and reconnect them for the IPOD2CAR to operate. Toyota / Scion/ Isuzu / Honda-Passport 1 2 3 4 5 6 7 8 SETTINGS ON ON OFF ON OFF OFF OFF ON FOR TOYOTA Toyota 1998 – 2005 – Connects behind the radio 2003 and newer :4R
ملخص المحتوى في الصفحة رقم 16
VEHICLE INSTALLATION Volkswagen Make sure you have your radio’s theft protection code before you attempt installation. When you reconnect power to the battery, you will need to enter this code. Information about the theft protection code can be found in your vehicle’s audio operation manual. Before connecting any cables to the black box you must set the dip switch to the VW position. If you set the dip-switches after you have connected cables to the box, you must disconnect and reconnec
ملخص المحتوى في الصفحة رقم 17
TROUBLESHOOTING Chapter 3 Symptom Cause Remedy No Power Blown fuse Replace fuse with same amp. Rating. If the fuse blows again, call tech support. No Power Bad connection Check cable connection. Alternator noise is heard Wrong wiring creates ground loop. Call tech support or ask a local (Changes with gas) car audio shop. Radio can’t recognize IPOD2CAR Bad cables or cables are not Check connection and cables, ADAPTER connected properly between push in firmly. converter box and car
ملخص المحتوى في الصفحة رقم 18
Notices, Warnings, and Warranty Info One Year Limited Warranty The quality controls used in the manufacture of this product ensure your satisfaction. This warranty applies only to the original purchaser of this product from an authorized dealer. This warranty covers any supplied or manufactured parts of this product that, upon inspection by SSI authorized personnel, is found to have failed in normal use due to defects in material or workmanship. This warranty does not apply to installati
ملخص المحتوى في الصفحة رقم 19
Caution 1. Use of headphones while operating an automobile or moving vehicle is not recommended and is unlawful in some countries and areas. 2. Be careful and attentive on the road. Stop operation of the IPOD2CAR ADAPTER if you find it disruptive or distracting while driving. The driver of a motor vehicle should not operate the IPOD2CAR ADAPTER while driving. FCC Class B Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class
ملخص المحتوى في الصفحة رقم 20
FORD Appendix IPOD2CAR ADAPTER Connection 2004 - Town Car, Grand Marquis, Marauder, LS and Ford Crown Vic. 1. Preparing the Ford-12pin Cable Take the Ford 12pin cable and cut off the black 12-pin harness. You will use only the cable and big White 22 pin connector (connects to the black box). 2. Connection to the Vehicle There are two connectors located behind the radio, a 16 pin connector and a 24 pin connector. We will first work with the 16 pin connector. 16pin Conne
