Blue Sea Systems PN 8095 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

W ARNING
Marine Electrical Products
] These instructions are intended to provide assistance with the
AC & DC Power Distribution Panel
installation of this product, and are not a substitute for a more
PN 8095 / PN 3095 / PN 8195 / PN 3195
comprehensive understanding of electrical systems. We strongly
recommend that a competent electrical professional perform the
Specifications
installation of this product.
Material: 0.125" 5052-H32 aluminum alloy
] If either the panel front

ملخص المحتوى في الصفحة رقم 2

DC Installation (continued) Next, connect a minimum 16 AWG red wire from the screw on the side of W ire Sizing Chart the shunt positive terminal to the meter positive terminal and connect a 1. Calculate the maximum sustained amperage of the circuit. Measure black or yellow wire from the shunt negative terminal to the meter the length of the circuit from the power source to the load and back. negative terminal. There should be a 1 ampere fuse in both sense wires 2. Does the circuit run

ملخص المحتوى في الصفحة رقم 3

AC Installation (continued) Reference 2. Install feed circuit wires Applicable Standards Install the feed wires from the shore power inlet or other AC source, • American Boat and Yacht Council (ABYC) Standards and Recommended referring to the wire sizing chart to select the correct wire size. Connect Practices for Small Craft sections: E-1, E-3, E-9. the black AC hot, white AC neutral and green AC safety ground as shown • United States Coast Guard 33 CFR Sub Part 1, Electrical System

ملخص المحتوى في الصفحة رقم 4

8704 Rev. 008 Page 4 of 4 1 AMP FUSES ADDITIONAL BREAKER REQUIRED IF GREATER THAN 10 FEET AC AC DC DC VOLTMETER AMMETER VOLTMETER AMMETER Red Red Red Red +12V +12V +12V +12V Orange Orange Orange Orange +24V +24V +24V +24V Yellow Yellow Yellow Yellow -Neg -Neg -Neg -Neg POSITIVE FEED 1 TO 2 AMP FUSE W iring Diagram AC/DC Power Distribution Panel PN 8095 / PN 8195 shown for reference