ملخص المحتوى في الصفحة رقم 1
LPB708A
LPB716A
LPB724A
8-/16-/24-Port 10/100 PoE PSE Web Smart Switch
Connect VoIP phones, IP cameras, or any PoE PD
devices through manageable, switched links.
Complies with 802.af Power-over Ethernet standard.
Supports Web-based configuration and management.
Uses Auto-MDI/MDI-X so you can use crossover
or straight-through cables.
Automatically determines port speed.
Housed in a desktop metal case
with an internal power supply.
Includes PoE ON/OFF remote control.
ملخص المحتوى في الصفحة رقم 2
8-/16-/24-Port 10/100 PoE PSE Web Smart Switch Federal Communications Commission and Industry Canada Radio Frequency Interference Statements This equipment generates, uses, and can radiate radio-frequency energy, and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication. It has been tested and found to comply with the limits for a Class A computing device in accordance with the specificati
ملخص المحتوى في الصفحة رقم 3
NOM Statement and CE Directive Normas Oficiales Mexicanas (NOM) Electrical Safety Statement INSTRUCCIONES DE SEGURIDAD 1. Todas las instrucciones de seguridad y operación deberán ser leídas antes de que el aparato eléctrico sea operado. 2. Las instrucciones de seguridad y operación deberán ser guardadas para referencia futura. 3. Todas las advertencias en el aparato eléctrico y en sus instrucciones de operación deben ser respetadas. 4. Todas las instrucciones de operación y uso d
ملخص المحتوى في الصفحة رقم 4
8-/16-/24-Port 10/100 PoE PSE Web Smart Switch Table of Contents 1. Specifications ..................................................................................................................................................................6 1.1 Hardware Specifications........................................................................................................................................6 1.2 Management Software Specifications ...................................
ملخص المحتوى في الصفحة رقم 5
Table of Contents 4.8 Spanning Tree ......................................................................................................................................................36 4.8.1 STP Bridge Setting ................................................................................................................................36 4.8.2 STP Port Setting ........................................................................................................
ملخص المحتوى في الصفحة رقم 6
8-/16-/24-Port 10/100 PoE PSE Web Smart Switch 1. Specifications Hardware Specifications Buffer Memory: LPB708A, LPB716A: Embedded 1625 K bits frame buffer; LPB724A: 2750 K bits Certifications: FCC Class A, CE Flow Control: IEEE802.3x compliant for full duplex; Backpressure flow control for half duplex Full Forwarding/Filtering Packet Rate: PPS (packets per second): Forwarding Rate Speed 148,800 PPS 100 Mbps 14,880 PPS 10 Mbps MAC Address and Self-learning: 4K MAC
ملخص المحتوى في الصفحة رقم 7
Chapter 1: Specifications Management Software Specifications Backup/Recovery Configuration IGMP Snooping: V1/V2 Port Management: Port Configuration, Port Mirroring, Bandwidth Control, Broadcast Strom Control, PoE On/ Off Setting QoS Setting: Up to 4 queues RSTP/STP: Rapid/Spanning Tree Protocol VLAN Function: Port-Based/802.1Q-Tagged, up to 256 active VLANs in one switch VLAN Setting: Port-based/Tag-based, VLAN ID: 1–4094K Security Filter: MAC address filtering, TC
ملخص المحتوى في الصفحة رقم 8
8-/16-/24-Port 10/100 PoE PSE Web Smart Switch 2. Overview 2.1 Introduction LPB708A/LPB716A/LPB724A, is a standard 8-Port/16-Port/24-Port 10/100 PoE PSE Web Smart Switch that meets all IEEE 802.3u/x Ethernet specifications. The switch includes 8-, 16-, or 24-Port 10/100Mbps TP ports. LPB724A also features two combo UTP/SFP Gigibit ports. Manage the switch through an Ethernet port using Web-based management. The switch also features QoS (Quality of Service), Spanning Tree, VLAN, Por
ملخص المحتوى في الصفحة رقم 9
Chapter 2: Overview 2.4 Front and Back Panels 2.4.1 Front Panel LED Indicators 8 RJ-45 TP ports LPB708A. LED Indicators (16) RJ-45 TP ports LPB716A. 2 Combo UTP/SFP LED Indicators 24 RJ-45 TP Ports Ports LPB724A. Figure 2-1. LPB708A, LPB716A, LPB724A Front panels. 2.4.2 Back Panel AC Power Input Figure 2-2. Back panel. 9 724-746-5500 l www.blackbox.com
ملخص المحتوى في الصفحة رقم 10
8-/16-/24-Port 10/100 PoE PSE Web Smart Switch 2.5 LED Indicators LPB708A LPB716A LPB724A Figure 2-3. LED Indicators. 10 724-746-5500 l www.blackbox.com
ملخص المحتوى في الصفحة رقم 11
Chapter 2: Overview Table 2-1. LED descriptions. LED Color Function Systems LED (All models) Power Green Lit when power is on Reset Used to restore management system 10/100 Ethernet TP Port 1 to 8 LEDs (LPB708A) LINK/ACT Green Blinks when any traffic is present Off when connection is not good PoE Green Lit when PoE power is active 10/100 Ethernet TP Port 1 to 16 LEDs (LPB716A) LINK/ACT Green Blinks when any traffic is present Off when connection is not g
ملخص المحتوى في الصفحة رقم 12
8-/16-/24-Port 10/100 PoE PSE Web Smart Switch 3. Installation 3.1 Hardware and Cable Installation CAUTION: Wear a grounding device to avoid damage from electrostatic discharge. Be sure that the power switch is OFF before you connect the power cord to the power source. 3.1.1 TP Port and Cable Installation 1. The switch’s TP port supports MDI/MDI-X auto-crossover, so you can use both types of cable, straight-through (Cable pin-outs for RJ-45 jack 1, 2,
ملخص المحتوى في الصفحة رقم 13
Chapter 3: Installation 3.1.3 Power On The switch supports a 100-240 VAC, 50-60 Hz power supply. The power supply will automatically convert the local AC power source to DC power. It does not matter whether any connection is plugged into the switch or not when powering on. After the power is on, all LED indicators will light immediately and then all go off except the power LED, which stays on. 3.2 Installing Switch to a 19-Inch Wiring Closet Rail CAUTION: Allow a proper spacing
ملخص المحتوى في الصفحة رقم 14
8-/16-/24-Port 10/100 PoE PSE Web Smart Switch 3.4 Switch Cascading in Topology Theoretically, the switch partitions the collision domain for each port in switch cascading so that you may uplink an unlimited number of switches. In practice, the network extension (cascading levels and overall diameter) must comply with the IEEE 802.3/802.3u and other 802.1 series protocol specifications, which limit the timing requirement from physical signals defined by the Media Access Control (MAC)
ملخص المحتوى في الصفحة رقم 15
Chapter 3: Installation Case2a: Port-based VLAN (See Figure 3-4). VLAN 1 VLAN 2 VLAN 3 VLAN 4 Figure 3-4. One switch connected to four VLANs in a port-based VLAN. 1. The same VLAN members can not be in different switches. 2. Every VLAN members can not access each other’s VLAN. 3. The switch manager has to assign different names for each VLAN groups at one switch. Case 2b:
ملخص المحتوى في الصفحة رقم 16
8-/16-/24-Port 10/100 PoE PSE Web Smart Switch Case 3: The same VLAN members can be at different switches with the same VID (See Figure 3-6). VLAN 1 VLAN 2 VLAN 3 Figure 3-6. Attribute-based VLAN diagram. 3.6 Set IP Address, Subnet Mask, and Default Gateway IP Address First, either configure your PC IP address or change IP address of the switch. Next, change the IP address of default gateway and subnet mask. For example, your network address is 10.1.1.0, and su
ملخص المحتوى في الصفحة رقم 17
Chapter 3: Installation NOTE: If a PC directly connects to the switch, you have to setup the same subnet mask between them. But, subnet mask may be different for the PC at the remote site. See the following about the switch’s default IP address information. Default IP address: 192.168.2.1 Default ID: admin Default Password: admin 2. Run a web browser and follow the menu. Figure 3-7. Login screen for Web. 17 724-746-5500 l www.bl
ملخص المحتوى في الصفحة رقم 18
8-/16-/24-Port 10/100 PoE PSE Web Smart Switch 4. Operation of Web-based Management This chapter instructs you how to configure and manage the switch through the web user interface it supports, to access and manage the switch. With this facility, you can easily access and monitor through any one port of the switch the status of the switch, including each port activity, Spanning tree status, port aggregation status, VLAN, and priority status and so on. The default values of the manag
ملخص المحتوى في الصفحة رقم 19
Chapter 6: IP Address Assignment In Figure 4-2, for example, the left section shows the whole function tree with web user. Each option is described in this chapter. Port Connection Status Configuration Content Screen Configuration Function Bar Figure 4-2. Layout of screen for web management. 4.1 Web Management Home Overview After you login, the screen shown in Figure 4-3 appears. Select one of the configurations by clicking on the icon in the configuration bar
ملخص المحتوى في الصفحة رقم 20
8-/16-/24-Port 10/100 PoE PSE Web Smart Switch System Status Load Default Setting Firmware Update Reboot Device 4.2.1 Authentication Configuration Function name: Authentication Configuration Function description: Change the default login username (ID) or password. Parameter description: Username (ID): Type in the login name you’d like, the maximum characters are 15. Password: Type in the password you’d like, the maximum characters are 15. Click when you’r
