Dialogic Network Interface Board DNI2410TEPEHMPQ دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Pins
321
Alarm/Status
LEDs
SW1
by the edges and avoid touching the board's com-
Physical Layout ponents.
3. Lay the board on the static-dissipative work sur-
face.
Note: Place board in static-shielding bag when carry-
CT Bus
Connector ing board from station to station.
Key:
R3 R7 R5 R1 L5
L1
G=Green
L2 Y3 Y7 Y5 Y1 L6
L=Loopback (Red)
® L3 G3 G7 G5 G1 L7 CAUTION: Do not remove the board from the anti-
Dialogic
R=Red
L4 R4 R8 R6 R2 L8
static packaging until you are ready to install it. Ob-
Y=Yel

ملخص المحتوى في الصفحة رقم 2

To terminate the CT Bus, install a link clip over the does support the DNI2410TEPEHMPQ before config- 5. Installing the Board CT Bus pair of P5 pins indicated in the following figure. Colored uring the system for the newly installed board(s). Cable Stripe WARNING! Unplug the equipment before per- Please refer to the Release Update document for your (Pin 1) forming the procedures described in this sec- Dialogic software version for up-to-date information tion. Failure to disconnect the power b