ملخص المحتوى في الصفحة رقم 1
3Wood Cast Iron Boiler
SAVE THESE INSTRUCTIONS
Must be installed by
For wood and
a qualified licensed
soft coal only.
Heating Contractor.
IMPORTANT:
OWNER:
PLEASE READ THESE INSTRUCTIONS
For service and repairs to the
CAREFULLY BEFORE PROCEEDING WITH
heating system, please contact your
THE INSTALLATION OF THE BOILER.
Heating Contractor. The following
THESE INSTRUCTIONS MUST BE POSTED
information should be filled in by
NEAR THE BOILER AND MAINTAINED IN
your Heating Contracto
ملخص المحتوى في الصفحة رقم 2
Dear Customer, Thank you for buying a BIASI 3Wood Boiler. The 3Wood Boiler system is a cast iron, solid fuel, hot water boiler, using the famous Biasi (3-pass) design. This Boiler is rugged and engineered for maximum heating efficiency. We realize that it is not possible to answer all the questions about the 3Wood Boiler System in this manual. Reading this installation Manual does not make the reader an expert in all aspects of installation and operation, and does not replac
ملخص المحتوى في الصفحة رقم 3
Table of Contents 4 Important Information 5-6 Warnings and safety rules, Identification 7 Procedure in event of power failure 8 Refueling the Boiler 9 Wood Burning 10 Heat value of wood, Wood Storage, Ash Removal 11 Creosote, Runaway Fire 12 Chimneys 13 Coal Firing 14 3Wood Design 15 Installation Considerations 16 Layout of Main Components 17 Transporting and Minimum Clearances 18 Flue Gas Out
ملخص المحتوى في الصفحة رقم 4
IMPORTANT INFORMATION Please read this page carefully. ALL BOILERS MUST BE INSTALLED IN ACCORDANCE WITH NATIONAL, STATE AND LOCAL PLUMBING, HEATING AND ELECTRICAL CODES AND ORDINANCES, AS WELL AS THE REGULATIONS OF THE SERVING ELECTRICAL, WATER AND GAS UTILITIES. All systems should be designed and installed by licensed heating contractors who are knowledgeable in the layout and installation of multi-fuel heating systems. WARNING · The 3WOOD Boiler must be positioned to provide at
ملخص المحتوى في الصفحة رقم 5
WARNING SAFETY RULES · After removing the packaging, check that the material supplied is intact and complete; if this is not the case, contact the heating contractor that sold the 3WOOD Boiler. · The 3WOOD Boiler must be installed by a licensed heating contractor in compliance with the National, State and Local codes in force and the instructions provided in the manual supplied with the 3WOOD. · The 3WOOD Boiler must be used for the intended purpose. Q
ملخص المحتوى في الصفحة رقم 6
WARNING -Canadian · Operate the (gas, Oil, Electric) boiler periodically to ensure that it will operate satisfactory when needed. · DO NOT relocate or by-pass any of the safety controls in the original boiler installation. · The operation of the gas boiler must be verified for acceptance operation before and after installation of the add-on boiler by a gas filter who is recognized by a regulatory body. Note: Only wood and bituminous coal can be burned in this boiler. IDENTIFICATION T
ملخص المحتوى في الصفحة رقم 7
PROCEDURE IN EVENT OF POWER FAILURE Should your electricity go off during the heating season, there are several procedures that should be followed in order that you may continue to safely operate your heating system. These procedures apply to the solid-fuel boiler, as the gas or oil-fired boiler, if any, will be completely inoperative. 1. Locate any flow-check valves in the system (See Pg. 7), and completely unscrew the knob on the top of all these valves. (This will allow a certain
ملخص المحتوى في الصفحة رقم 8
REFUELING THE BOILER CAUTION · Use extreme caution when refueling the boiler. If the door is opened too quickly, the unburned hot gases may ignite and cause a back puff. This is especially true with very dry wood. · DO NOT tamper with the chain on the draft regulator as it could cause the fire to burn out of control. · Keep ash and fuel doors closed if not refueling boiler. · DO NOT overload the boiler. Adjusting the Flue Gas Dam
ملخص المحتوى في الصفحة رقم 9
WOOD BURNING Overview Burn dry and well-seasoned hardwood with a moisture content of 20% or less. Wood must be seasoned at least six months; however, it is preferable to season it for a year to eighteen months. Seasoned wood will not only reduce creosote but will also produce more heat. Some sea- soned hardwoods will yield 20-25% more heat. Wood-burners who ignore this advice are likely to have dirty chimneys and inadequate performance from their boilers. Theoretically, th
ملخص المحتوى في الصفحة رقم 10
The Heat Value of Wood The following chart compiled by the United States Forest Products Laboratory indicates the amount of heat available per cord of wood from a few representative tree species. Other good to very good species would include apple, walnut, pecan, dogwood, cypress, sycamore and gum. The latter two are hard to split, as is elm. Available Heat Per Cord In Millions of BTU/ HR Green Wood Air-Dry Percent More Heat For Air-Dry Wood Species Ash 16.5 20.0 21 As
ملخص المحتوى في الصفحة رقم 11
CREOSOTE Creosote condenses from the flue gases more quickly when the temperature in the chimney is low. The actual amount of creosote deposited is dependent on: 1. The amount of moisture in the flue gases. 2. The temperature of the stack, 3. The rate at which the wood is burned. 4. The amount of draft in the stack. 5. How completely the combustible elements in the flue gases have been burned in the combustion chamber. Most problems with creosote are due to insufficiently dry wo
ملخص المحتوى في الصفحة رقم 12
Chimneys WARNING Do NOT connect this unit to a chimney flue serving another appliance. Downdrafts Downdrafts can result from improper chimney height, nearby buildings, tree that are taller then the chimney, and too large of a flue. To help minimize this problem, the top of the chimney must be at least three feet above the point at which it passes through the roof and two feet above the highest point of the roof. In addition, the chimney should be at least as high or higher than t
ملخص المحتوى في الصفحة رقم 13
COAL FIRE DANGER COAL FIRES CAN PRODUCE POISONOUS GASES! All coal fires produce large quantities of carbon monoxide (CO) a highly poisonous gas. Exposure to this gas produces drowsiness, sleep, and in some cases, brain damage or even death. Since carbon monoxide is odorless and colorless, the victim is rarely aware that he or she is being overcome until it is too late. Normally, carbon monoxide burns as a blue flame over the coal bed, but under any of the following conditions, unb
ملخص المحتوى في الصفحة رقم 14
The 3WOOD Design The 3WOOD Boilers are hot water generators that operate by combustion of hard wood or soft coal. They feature a high quality and extremely thick ASME class 20 cast-iron body, protected by high-density insulation that limits heat loss. The large heat exchange surface and the fins in the flue gas path ensure exceptional resistance to corrosion and very high efficiency that remains constant over time (self-cleaning effect). The combustion chamber and the upper door f
ملخص المحتوى في الصفحة رقم 15
Installation considerations When the 3WOOD is installed, check that The flue, if reused: · Supplies the negative pressure required for the new boiler (see the table of technical specifications on page 10); · is suitable for the temperature of the products of combustion, and has been calculated and constructed according to the required standards; recommended by NFPA · is as straight as possible, airtight, insulated and is not blocked or choked; · is fitted with a cleanout door ·
ملخص المحتوى في الصفحة رقم 16
LAYOUT OF THE MAIN COMPONENTS Pressure Gauge Flame Inspection Window 1. 13. 2. Temperature Gauge 14. Loading Door 3. Flue Gas Chamber 15. Draft Regulator 4. Mobile Smoke Plate 16. Flue Attachment Loading / Combustion Chamber Flue Gas Damper 5. 17. 6. Flue Gas Baffle 18. Flue Cleanout Door 7. Ash Collection Chamber 19. Casing 8. Ash Pit Door 20. Insulation Ash Tray 1 1/2 Flange for Overheat control 9. 21. 10. Primary Air Damper 22. 1 1/2 Nipple (Supply Outlet) 11. Secondary Comb
ملخص المحتوى في الصفحة رقم 17
Transporting Once the packaging has been removed, cut the straps and remove the casing in such a way as to avoid damaging it. · If hoisting equipment is available, suitable for the weight of the boiler, use the eyebolts (1) provided on the body to lift it · If no suitable hoisting equipment is available, handle the boiler manually, as follows: · Remove the fastening screws (2) for the baseboard (3) and take it off, so as to allow the pallet to be tilted · Insert a suitably
ملخص المحتوى في الصفحة رقم 18
WARNING FLUE GAS OUTLET The chimney and flue must be made in compliance with building codes and resistant to high temperature, condensate and mechanical stress, and that are airtight. · Do not connect to any chimney flue or vent servicing another appliance. · The 3WOOD takes in the combustion air from the room where the boiler is installed, which MUST FEATURE ventilation openings as required by NFPA standards. · The flue (1) must ensure the minimum negative draft between .07 an
ملخص المحتوى في الصفحة رقم 19
ASSEMBLING THE CASING A. Remove the outlet and return stubs from the cardboard box inside the loading/combustion chamber, and install them B. Fit a screw and nut in the holes on the four bottom brackets (1), without tightening them C. Insert them in the top of the four slots provided at the bottom of the boiler, and secure them with the nuts. NOTE: The four top brackets (2) have holes for fastening the paneling to the tie-rods D. Fit a bolt and nut in the holes on the four bott
ملخص المحتوى في الصفحة رقم 20
Installation of Controls A. Insert the temperature gauge (16) in the housing on the front panel (15) and secure it B. Partially unwind the capillary tube from the thermometer, insert the sensor in the probe socket (17) and secure it with the fastening spring C. Fit the front panel (15), handling the temperature gauge capillary tube to make sure it is not damaged, and inserting the regulator in the opening provided D. Secure it to the side panels using the screws supplied. E. Insert
