ملخص المحتوى في الصفحة رقم 1
1
Instruction Manual
VM-1800A / VM-2800A / VM-3800A
Hitachi Home Electronics (America), Inc. HITACHI (HSC) CANADA
INC.
3890 Steve Reynolds Blvd., Norcross, GA 30093 3300 Trans Canada Hwy.,
Pointe Claire,
Tel. 404-279-5600 Quebec, H9R1B1, CANADA
Tel. 514-697-9150
HITACHI SALES CORPORATION OF HAWAII, INC.
3219 Koapaka Street, Honolulu, HI 96819
Tel. 808-836-3621
Thank you for choosing the video camcorder. For maximum pleasure and
convenience please read these s
ملخص المحتوى في الصفحة رقم 2
WHEN USING WITH THE CAR BATTERY (By using optional car battery cord Hitachi VM- CC70A)................................................................................................................................................. 13 CHECKING THE BATTERY.................................................................................................................. 14 CHARGING A BATTERY ......................................................................................................
ملخص المحتوى في الصفحة رقم 3
CAUTIONS CAMCORDER TO VCR DUBBING.......................................................................................................51 FLYING ERASE HEAD .......................................................................................................................... 52 ATTACHING THE OPTIONAL TELE OR WIDE CONVERTER LENS............................................. 52 USING THE BUILT-IN CAMERA LIGHT (For VM-2800A/3800A)....................................................53 To rep
ملخص المحتوى في الصفحة رقم 4
CAUTIONS CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. "This digital apparatus does not exceed the Class B limits for radio emissions from digital apparatus as set out in the interference-causing equipment standard entitled " Digital Apparatus", ICES-003 of the Department of Communications." Warning: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful in
ملخص المحتوى في الصفحة رقم 5
PRECAUTIONS PRECAUTIONS Any problems that occur as a result of any of the following conditions will not be covered by our warranty. Be careful that no water, dust, or sand enters the camcorder. When you are not using the camcorder, switch off the power and attach the lens cap. When you shoot at a scene which contains an extremely bright object such as the the sun or a light source, a bright vertical bar may appear in the picture. Your camcorder is functioning properly, but
ملخص المحتوى في الصفحة رقم 6
IMPORTANT SAFEGUARDS This instruction manual shows the illustrations for the VM-3800A. * This video camcorder with this marking incorporates high-quality picture technology and is compatible with any video cassette recorder bearing the mark. ACCESSORIES Check to make sure you have the following components and accessories (besides the camcorder unit itself) before disposing of the packing material. 1. Lead-acid rechargeable battery VM-BP66 for VM-1800A/VM-2800A VM-BP67 for VM-3800
ملخص المحتوى في الصفحة رقم 7
IMPORTANT SAFEGUARDS your video product, safety is a major factor in the design of every instrument. But, safety is your responsibility too. This page lists important information that will help to assure your enjoyment and proper use of a Video Camcorder and accessory equipment. Please read it carefully before operating your video product and keep it in a handy place for future reference. INSTALLATION 1 Read and Follow Instructions -- All the safety and operating instructions should be
ملخص المحتوى في الصفحة رقم 8
IMPORTANT SAFEGUARDS likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. 8 Ventilation -- Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the video product and to protect it from overheating. These openings must not be blocked or covered. The openings should never be blocked by placing the video prod
ملخص المحتوى في الصفحة رقم 9
ملخص المحتوى في الصفحة رقم 10
IMPORTANT SAFETY INSTRUCTIONS FOR AC ADAPTER/CHARGER SERVICE 17 Servicing -- Do not attempt to service this video product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. 18 Conditions Requiring Service -- Unplug this video product from the wall outlet and refer servicing to qualified service personnel under the following conditions. a. When the power-supply cord or plug is damaged b. If
ملخص المحتوى في الصفحة رقم 11
ELECTRONIC VIEWFINDER when disconnecting charger. 8. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. 9. Do not operate charger with damaged cord or plug--replace them immediately. 10. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure: A. That the pins on plug of extension cord are
ملخص المحتوى في الصفحة رقم 12
POWER SOURCES 2. Turn the eyepiece. You can adjust the position and angle of the viewfinder so you can see through it easily. Cautions: Do not force the viewfinder to rotate completely around. This will damage the viewfinder and/or camcorder. When pulling the viewfinder out or returning it to its original position, hold the viewfinder by the swivel selection. Do not hold the diopter control side. POWER SOURCES WHEN USING WITH THE BATTERY (Provided) 12
ملخص المحتوى في الصفحة رقم 13
POWER SOURCES To attach, align the mark " " of the battery with that of the camcorder so that the battery fits into the groves, and slide the battery downward, as illustrated. To remove the battery: Push and hold "Battery" release lever, then slide the battery to the upside and remove. WHEN USING WITH THE AC ADAPTER/CHARGER (Provided) 1. Plug the AC adaptor/charger power cord into AC electrical outlet. 2. Connect one end of the DC cord (provided) to the "DC IN 9.6V" of the AC ada
ملخص المحتوى في الصفحة رقم 14
CHECKING THE BATTERY 1. Connect the small plug of the car battery cord to the "DC IN 9.6V" jack of the camcorder. 2. Connect the other end of the car battery cord to the car's cigarette lighter socket. NOTES: The car battery cord is designed to be used only with automobiles having a 12-volt negative ground system. To prevent fire or shock hazard or damage to your camcorder, please use only the specified car battery cord. CHECKING THE BATTERY When the " " indication appears in the
ملخص المحتوى في الصفحة رقم 15
CHARGING A BATTERY CHARGING A BATTERY 2 1. Plug the AC adaptor/charger power cord into AC electrical outlet. 2. Attach the battery to the AC adaptor/charger. Align the mark " " on the battery with that of AC adaptor/charger and push the battery flush with the AC adaptor/charger and slide it in the direction of arrow. NOTE: You must remove the DC cord from the AC adaptor/charger to charge the battery. If the DC cord is connected, "CHARGE" light will not light. 3. The "CHARGE" lig
ملخص المحتوى في الصفحة رقم 16
MAKING A SAMPLE RECORDING The battery may be damaged if operated at temperatures above 122ºF (50ºC). Operation time will decrease at extremely low temperatures. 7. After repeated chargings and use, the operation time will gradually decrease. When operation time becomes too short to be useful, it is time to replace the battery. 8. If "CHARGE" and "POWER" lights on the AC adaptor/charger start flashing, remove the battery and then reattach it. If after several attempts both lights continue t
ملخص المحتوى في الصفحة رقم 17
MAKING A SAMPLE RECORDING 4. Press and hold the small button on "POWER" switch, and then slide it to the "CAM" position. The "POWER" indicator will light and the camcorder will enter record/pause mode automatically. NOTES: If the erase prevention tab on the cassette is removed, the "TAPE" indication in the viewfinder flasher for several seconds and the camcorder will not enter record/pause mode. See page 43 for "EYEPIECE ADJUSTMENT". 5. Now, press "REC/PAUSE" button to start shoo
ملخص المحتوى في الصفحة رقم 18
MAKING A SAMPLE RECORDING 7. After recording, press and hold the small button on the "POWER" switch, and then slide it to "VIDEO". The camcorder will now be in the stop mode. 8. Press "REW" button. The tape will be rewound to the beginning 9. Press "PLAY" button. The picture you just recorded will be seen through the viewfinder. NOTE: If you connect the camcorder to your TV, you can see the picture played back on your TV. Refer to "VIEWING THE PICTURE PLAYED BACK ON YOUR TV" on page 3
ملخص المحتوى في الصفحة رقم 19
AUTOMATIC REWIND 12. Always remove the power source from the camcorder after use. NOTE: If you have a cassette tape that has already been partially recorded on and you want to record the remaining blank section, see "QUICK EDIT" on page 27. AUTOMATIC REWIND When the tape reaches its end during playback, it automatically rewinds to the beginning and stops. IDENTIFICATION AND OPERATION OF CONTROLS Diagram of camera Diopter Control (for VM-2800A/3800A) Use this control to focus the
ملخص المحتوى في الصفحة رقم 20
IDENTIFICATION AND OPERATION OF CONTROLS off automatically or manually in the record and record/pause modes depending on the position of "LIGHT" switch. Turn the camera light off after use. NOTE: The camera light turns on only in the record and record/pause modes. Microphone Sensitive to sounds coming from the direction in which the camera is pointed. 3 "FOCUS" Control (AUTO/MAN) Button (only for VM-3800A) Press these buttons simultaneously to select manual or automatic focus. For manual
