ملخص المحتوى في الصفحة رقم 1
R9947
3-band PLL
Synthesised Stereo Radio
ROBERTS
Sound for Generations
ملخص المحتوى في الصفحة رقم 2
Contents Controls ................................................... 2-3 Sleep timer ............................................... 17 Display ........................................................ 4 Display modes .......................................... 18 Inserting batteries ...................................... 5 Display backlight ...................................... 18 Battery replacement ................................... 6 Lock switch .............................................
ملخص المحتوى في الصفحة رقم 3
Controls - front 12 3 4 5 6 1. Preset button 7 2. Display button 3. Mono/Alarm button 8 4. Band/Time set button 5. On/Off button 6. Light button 7. Tuning up button 8. Tuning down button 9 9. Preset buttons If you need any further advice, please call our Technical Helpline on :- 2 020 8758 0338 (Mon-Fri)
ملخص المحتوى في الصفحة رقم 4
Controls - left & right sides 15 10. Volume control 11. Loudspeaker/Headphone switch 10 12. Headphone socket 13. DC input socket 16 14. Lock switch 11 14 15. Telescopic Aerial 16. Earphones 12 13 3
ملخص المحتوى في الصفحة رقم 5
Display A BC D E F A. Sleep time indicator B. Alarm indicator C. Stereo indicator D. Key lock indicator E. +5 indicator F . Preset indicator G G. Low battery indicator H. MHz/kHz indicators I . Frequency/Time display J . Waveband and AM/PM indicators J I H If you need any further advice, please call our Technical Helpline on :- 4 020 8758 0338 (Mon-Fri)
ملخص المحتوى في الصفحة رقم 6
Inserting batteries 1. Position your radio face down. 2. Press the catch as shown and slide in the direction of the arrow. 3. Lift up the battery cover 4. Insert 2 x LR6 (AA) size batteries as shown in the diagram. 5. Close the battery cover. 6. The clock will start running when the 2 LR6 (AA) size batteries are installed. When batteries are installed for the first time the display will show 0:00. The seconds dis- play will start to count as soon as batteries are installed. 5
ملخص المحتوى في الصفحة رقم 7
Battery replacement 1. The battery indicator will appear and flash in the display when the batteries are in need of replacement . After removing the batteries, you have approximately 3 minutes to replace the batteries after which clock and memory information will be lost . If you need any further advice, please call our Technical Helpline on :- 6 020 8758 0338 (Mon-Fri)
ملخص المحتوى في الصفحة رقم 8
Setting the clock Note: the time can only be set with the radio switched off. 1 2 1. Ensure that the radio is switched off. 2. Press and hold down the Time set button until the hours digit begins to flash in the display. 3. Whilst the hours digit is flashing adjust the hours using the Tuning up/down buttons. The clock uses a 12 hour display with AM/ PM indicators. Please ensure that the correct 12 hour cycle is selected. 3 3 7
ملخص المحتوى في الصفحة رقم 9
4. Press the Time set button, the minute digit begins to flash in the display. 4 5. Whilst the minute digit is flashing adjust the minutes using the Tuning up/down but- tons. 6. Press the Time set button to complete time setting 5 6 5 If you need any further advice, please call our Technical Helpline on :- 8 020 8758 0338 (Mon-Fri)
ملخص المحتوى في الصفحة رقم 10
Setting the alarm time 1. Ensure that the radio is switched off. 2. Press and hold down the Alarm button 1 2 until the hours digit begins to flash in the display. 3. Whilst the hours digit is flashing adjust the hours using the Tuning up/down buttons. 3 3 9
ملخص المحتوى في الصفحة رقم 11
4. Press the Alarm button, the minute digit begins to flash in the display. 4 5. Whilst the minute digit is flashing adjust the minutes using the Tuning up/down but- tons. 6. Press the Alarm button to complete the alarm time setting 5 6 5 If you need any further advice, please call our Technical Helpline on :- 10 020 8758 0338 (Mon-Fri)
ملخص المحتوى في الصفحة رقم 12
Wake to alarm 1. Set the alarm time as previously described. 2. Switch off your radio using the On/Off 2 3 button. 3. Repeatedly press and release the Alarm button until the symbol appears in the display. 4. At the preselected time the alarm will sound. The alarm may be turned off for 24 hours by pressing any button. The alarm will switch off automatically after 3 minutes. 5. To permanently cancel the buzzer alarm repeatedly press and release the Alarm button until the symbol is removed from
ملخص المحتوى في الصفحة رقم 13
Operating your radio - search tuning 1. Switch on your radio by pressing the On/ Off button. 2 2 2. Select the required waveband by repeat pressing of the Band button. The wave- band selected will appear in the display. On FM fully extend the Telescopic aerial. On MW and LW rotate your radio for best reception. 3. Press and hold down either the Tuning + or - buttons until the frequency in the display 3 begins to change rapidly. Release the but- ton. 4 4. Your radio will scan the selected wave-
ملخص المحتوى في الصفحة رقم 14
Operating your radio - manual tuning 1. Switch on your radio by pressing the On/ Off button. 2 2 2. Select the desired waveband using the Band button. The waveband selected will appear in the display. On FM fully extend the Telescopic aerial. On MW and LW rotate your radio for best reception. 3. A single press on either the Tuning + or - 3 buttons will change the frequency up or down. The frequency steps are:- FM 50kHz, MW 9kHz and LW 9kHz. Adjust the Vol- 4 ume control to the required level. 3
ملخص المحتوى في الصفحة رقم 15
MW (AM) tuning step size In Europe and other parts or the world MW tuning steps are 9kHz, in America the MW 1 tuning step size is 10kHz. To change the MW tuning step size from 9KHz to 10KHz proceed as follows:- 1. Switch off your radio. 2. Press and hold down Tuning up button. 2 3. Whilst holding down the Tuning up button 3 press the On/Off button. To change tuning steps from 10kHz back to 9kHz repeat the above using the Tuning down button in step 2 instead of the Tuning up button. If you need
ملخص المحتوى في الصفحة رقم 16
Presetting stations You may store up to 10 stations on FM, 10 on MW and 10 on LW giving a total of 30 preset 1 stations. 1. Press the On/Off button to switch on the radio. 3 2. Tune to the required station using one of the methods previously described. 3. Press and hold down the required Preset button until the radio beeps (greater than 2 seconds) The station will be stored under the chosen preset button. 4. Presets 6-10 are obtained by first pressing the +5 button. 5. Stations stored in preset
ملخص المحتوى في الصفحة رقم 17
Recalling a preset station 1. Switch on your radio using the On/Off button. 1 2 2. Select the desired waveband using the Band button. 3. Press one of the Preset buttons 1-5 to 3 recall the station. 4. Presets 6 to 10 are obtained by pressing the +5 button and Preset button 1 to 5. e.g preset 7 can be recalled by pressing +5 button followed by Preset button 2. 4 If you need any further advice, please call our Technical Helpline on :- 16 020 8758 0338 (Mon-Fri)
ملخص المحتوى في الصفحة رقم 18
Sleep timer Your radio can be set to turn off after a preset time has elapsed. 1 1. Ensure that your radio is switched off. 2. Press and hold down the On/Off button until the desired time is reached (maximum 90 minutes in 30 minute steps). The radio will switch off after the sleep time has elapsed. 3. To cancel the sleep function before the preset time has expired, press the On/Off button. 1 17
ملخص المحتوى في الصفحة رقم 19
Display Modes 1. Whilst tuned to a station you can change between station name/frequency, alarm and 1 normal time display by repeated pressing of the Display button. Display backlight 1. Pressing the Light button will switch on the display backlight and illuminate the display for approximately 7 seconds. 1 If you need any further advice, please call our Technical Helpline on :- 18 020 8758 0338 (Mon-Fri)
ملخص المحتوى في الصفحة رقم 20
Lock Switch The Lock switch located on the right side of your radio is used to prevent unintentional operation. 1. Slide the Lock switch to the up 'locked' position, the symbol will appear in the display. The Power and all other but- tons will be disabled. This will prevent acci- 1 dental operation when the radio is packed in a suitcase. To release the Lock switch move the switch to the down 'unlocked' position, the symbol will be re- moved from the display. 19
