ملخص المحتوى في الصفحة رقم 1
Storm Series
Indoor/Outdoor Speakers
O41/O51/O61/O62/O62ST
www.atonhome.com
ملخص المحتوى في الصفحة رقم 2
ملخص المحتوى في الصفحة رقم 3
Storm Series Outdoor Speakers 1. Introduction Thank you for choosing ATON Storm Series Outdoor Speakers. All models were voiced in our sound labs by musicians with years of critical listening experience and crafted for your listening enjoyment. To see the complete line of ATON products, visit us online at www.atonhome.com. Storm Series Outdoor Speakers are designed to extend the listening experience into areas not traditionally associated with high quality sound: the Great Outdoors! The 041/O
ملخص المحتوى في الصفحة رقم 4
Storm Series Outdoor Speakers 2. System Design/Applications ATON Outdoor speakers are designed primarily to be used in areas such as back yards, porches, decks, etc. Because of the diversity of possible installation scenarios, pay particular attention to which type of application is most appropriate for the environment in which the speakers will be installed. Stereo In areas that have a defi ned listening area where two speakers will be mounted more or less equidistant from each other, use a
ملخص المحتوى في الصفحة رقم 5
Storm Series Outdoor Speakers 3. Installation The Installation process is divided into three distinct processes: Wiring, Mounting, and Connection. After carefully considering the intended application (defi ning a Listening Area, Mono/Stereo, etc.) specifi c mounting locations can be decided upon. Once the specifi c locations are determined, installation can commence. Wiring Before actually running any wire or cable, take the time to look around each room or area of the house and plan your wir
ملخص المحتوى في الصفحة رقم 6
Storm Series Outdoor Speakers • One 4 conductor speaker wire runs from the amplifier to a stereo volume control, then one 2 conductor speaker wire runs to each stereo speaker. A/V Receiver/Amplifier Volume Control 2 4 Conductor + + Conductor Wire - - Wire + + - - Figure 3.4 - Wiring: Amplifi er to Speakers w/ Volume Control • Use any of the stereo wiring methods to connect to a DVC speaker. This example shows 2 separate 2 conductor speaker wires run from the amplifier to the
ملخص المحتوى في الصفحة رقم 7
Storm Series Outdoor Speakers Mounting Use the included Mounting Brackets to securely mount the speakers in the desired location. To install the brackets on wood surfaces, vinyl siding, etc.: 1. Place brackets in desired location. Screw 2. Mark location of holes at the narrow Location point of the keyhole cutout. 3. Drill pilot holes.. 4. Partially tighten screws. 5. Place the brackets in position, then tighten the screws. Figure 3.7 - Screw Location To install the brackets on b
ملخص المحتوى في الصفحة رقم 8
Storm Series Outdoor Speakers Once the brackets are mounted, place the speakers between each end of the bracket. Install a Bracket Knob on each end of the speaker as shown in Figure 3.10. Adjust the speaker to the desired location, and fi rmly tighten the Bracket Knob. Mounting Bracket Knob Bracket Screws Bracket Knob Figure 3.10 - Mounting Speaker to Bracket Connection Once the speakers are mounted, they can be connected to the wires previously installed. Cut the ends of the wire to length, a
ملخص المحتوى في الصفحة رقم 9
Storm Series Outdoor Speakers 4. Specifications O41 System Type ....................................................................................................................................................................... 2-Way Woofer ........................................................................................................................... 4.25" Injection Molded Graphite (IMG) Tweeter .....................................................................................
ملخص المحتوى في الصفحة رقم 10
Storm Series Outdoor Speakers Notes: Page 8 ©2007 • All rights reserved.
ملخص المحتوى في الصفحة رقم 11
ملخص المحتوى في الصفحة رقم 12
Limited Warranty ATON* warrants to the purchaser/end user (“you”) that Storm Series Outdoor Speakers are to be free from defects in materials and workmanship for a period of ten (10) years from date of purchase (the “Warranty Period”). This warranty is transferable to subsequent owners of the product as long as the original proof of purchase is retained. If you discover a defect in material or workmanship within the Warranty Period, you can obtain warranty service by contacting ATON durin
