American Power Conversion 325I دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Installation
2 3
1
Placement / Power Connect Equipment Switch on the
Avoid placing the Back-UPS in:
to the Back-UPS Back-UPS
® The rear panel of the Back-UPS consists of the Note: Allow the Back-UPS to charge for a full eight
• Direct sunlight
following elements: hours prior to use.
• Excessive heat
Press the push-button on Back-UPS front panel.
Battery Back Up Outlets (qty. of 3). These
• Excessive humidity or in contact with fluids
outlets provide battery back-up, surge protection,
of an

ملخص المحتوى في الصفحة رقم 2

Troubleshooting Specifications Use the tables below to solve minor Back-UPS installation and operation problems. Consult APC On-line Input Voltage (on line) 180 - 264 Vac (default setting) Technical Support or call APC Technical Support for assistance with problems that cannot be resolved using this document: Frequency Limits (on line) 47 - 63 Hz (autosensing) On Battery Waveshape Stepped Sine Wave Possible Cause Procedure Maximum Load 325 VA - 195 W 475 VA - 285 W Back-UPS will not switch