American Power Conversion SMARTUPS 700 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Setup
®
Power the UPS
Connect Battery Wire (must be completed FIRST)
The UPS is shipped with one battery wire disconnected, in compliance with Department of Transportation Position the UPS to avoid:
(DOT) regulations. Connect the battery wire as shown. The UPS will NOT operate unless the steps
• Direct sunlight
below are performed.
w w w.apc.com
• Excessive heat
• Excessive humidity or contact with liquids.
®
Back-UPS LS
Plug the UPS directly into a wall outlet.
350/500/700
a. Set the UPS at th

ملخص المحتوى في الصفحة رقم 2

Status Indicators Four Beeps Every 30 Seconds: This alarm is sounded whenever There are four indicator lights (numbered for easy the UPS is running On Battery. Circuit Breaker: The circuit breaker button will stick out if identification below) and a speaker grille on the front an overload condition forces the UPS to disconnect itself panel to indicate UPS status, as folllows: Continuous Beeping: This alarm is sounded whenever a low battery from utility power. If this happens, disconnect