ملخص المحتوى في الصفحة رقم 1
HDP410
HDP420
HDP460
1080p DLP™ Projector
Users Manual v1.3
ملخص المحتوى في الصفحة رقم 2
2 FCC Warning Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guara
ملخص المحتوى في الصفحة رقم 3
3 TABLE OF CONTENTS Safety Warnings 4 Introduction 5 Positioning the projector 7 Choosing the aspect ratio 8 Video connectors 8 Connecting a video device 9 Composite (RCA) video connection 9 S-video connection 9 Component (RCA) connection 9 SCART RGB connection 9 Digital connections 10 DVI connection 10 HDMI connection 10 Computer connections 10 RS-232 connections 10 Displaying an image
ملخص المحتوى في الصفحة رقم 4
8’ / 2.4 m 3’ / 1 m 3’ / 1 m 4 Important Operating Considerations for Safety • Place the projector in a horizontal position no greater than 15 degrees off axis. • Locate the projector in a well-ventilated area without any obstructions to intake or exhaust vents. • Do not place the projector on a tablecloth or other soft covering that may block the vents. • Locate the projector at least 4' (1.2 m) away from any heating or cooling vents. • Use only Knoll-approved ceiling mounts. • Use
ملخص المحتوى في الصفحة رقم 5
5 Introduction Congratulations and thank you for your choice of a superior digital image projection device. Your new Knoll projector is specifically designed for home cinema applications. The projector sets a high standard using the latest DLP™ technology and new DNX video processing from Pixelworks™. This projector has 1920 x 1080 resolution (1080p). Whether you are watching movies or High Definition broadcasts or playing the latest video game, you will enjoy amazing image quality.
ملخص المحتوى في الصفحة رقم 6
6 M1-DA/DVI 12 VDC triggers RS-232 IR input HDMI Rear Connector Panel S-video Composite RCA Component video The projector provides the following connection options: • M1-DA/DVI (Digital Visual Interface) for DVI connection an M1-DA to DVI adaptor is required. • HDMI™ (High Definition Multimedia Interface) • Component (RCA) • SCART RGB (you must en
ملخص المحتوى في الصفحة رقم 7
7 Setting up the Projector There are a number of factors to consider when determining where to set up the projector, including the size and shape of your screen, the location of your power outlets, and the distance between the projector and the rest of your equipment. But here are some general guidelines. NOTE: To ensure adequate cable access, do not place the projector within 6 inches (0.15 m) of a wall or other object. Position the projector on a flat surface (
ملخص المحتوى في الصفحة رقم 8
8 HDP410, HDP420 and HDP460 Projection Throw Distance 16:9 Video Screen: Screen Diagonal 92" 103" 106" 110" 122.5" 146.75" Minimum Distance 149" 166" 171" 178" 198" 237" Maximum Distance 178" 199" 205" 212" 237" 284" Screen offset 16" 18" 19" 20" 23" 26" Viewing Area 45"x80" 50.5"x89.75" 52"x92" 54"x96" 60"x107" 72"x128" MAXIMUM DISTANCE TO SCREEN (16:9) = 1.935 x SCREEN DIAGONAL SIZE MINIMUM DISTANCE TO SCREEN (16:9) = 1.612 x SCREEN DIAGONAL SIZE SCREEN OFFSET (IMAGE DROP OR RISE) (16
ملخص المحتوى في الصفحة رقم 9
9 Video Connectors Component RCA M1-DA/DVI 12 VDC triggers RS-232 IR input HDMI Rear Connector Panel S-video Composite RCA Component video The first step for connecting video is determining what type of output connectors your video Component RCA device has. If there is more than one output, select the one with the highest quality. The best quality r
ملخص المحتوى في الصفحة رقم 10
10 Composite (RCA) video connection Plug the composite video cable’s yellow connector into the video-out connector on the video device. Plug the other yellow connector into the yellow Composite connector on the projector. S-video connection If your video device uses a round, four-prong S-video connector, plug the S-video cable into the S-video connector on your video device and into the S-video connector on the projector. Component (RCA) connection If your device uses component conne
ملخص المحتوى في الصفحة رقم 11
11 Computer connections You can connect a computer’s VGA connector to the M1-DA/DVI input on the projector using an M1-A cable. RS-232 connections You can control the projector from an LCD control panel or computer by connecting an RS-232 cable to the projector’s Serial control connector. Displaying an image Connect the power cord to the Power connector plug in power cord on the back of the projector and to your electrical outlet. NOTE: Always use the pow
ملخص المحتوى في الصفحة رقم 12
12 Your projector has been factory optimized for adjust Picture menu options excellent performance no matter what the source. including Aspect Ratio However, if you wish to make further changes you can optimize the image using on screen menus. Adjust the Contrast, Brightness, Color, Tint, or Aspect Ratio in the Picture menu. See page17 for help with the menus and these adjustments. For Aspect Ratio, keep in mind that DVD players must be configured for 16:9
ملخص المحتوى في الصفحة رقم 13
13 The following tables show common problems. In some cases, more than one possible solution is provided. Try the solutions in the order they are presented. When the problem is solved, you can skip the additional solutions.
ملخص المحتوى في الصفحة رقم 14
14
ملخص المحتوى في الصفحة رقم 15
15 Still need assistance? If you need assistance, visit our website at www.knollsystems.com, or call us at 1 800 566 5579. during Pacific west coast time. This product is backed by a limited warranty. An extended warranty plan may be purchased from your retailer or dealer. When sending the projector in for repair, we recommend shipping the unit in its original packing material, or having a professional packaging company pack the unit. Please insure your shipment for its full
ملخص المحتوى في الصفحة رقم 16
16 Using the remote control The remote uses two provided AA batteries. They are easily installed by sliding the cover off the remote’s back, aligning the + and - ends of the batteries, sliding them into place, and then replacing the cover. Navigation buttons To operate, point the remote at the projection screen or at the front of the projector (not at the video device or computer). The range of optimum operation is up to 30 feet (9.14m).
ملخص المحتوى في الصفحة رقم 17
17 • Turn on Overscan to remove noise on the edges of the video image (page 19). • Change the Aspect ratio (page18). Aspect ratio is the ratio of the image width to image height. TV screens are usually 1.33:1, also known as 4:3. HDTV and most DVDs are 1.78:1, or 16:9 (the projector’s default). Choose the option that best fits your input source in the menus, or press the Resize button on the remote to cycle through the options. See page16. • Select a specific Color Space. See page 20. •
ملخص المحتوى في الصفحة رقم 18
18 Menu options are grayed out only if the source is selected but no signal is present. For example, if the projector is set to a video source but the source, such as a DVD player, is turned off video menu options are grayed out. Picture Menu Increasi
ملخص المحتوى في الصفحة رقم 19
19 Gamma: Gamma tables contain preset intensity configurations optimized for the input source. You can select a gamma table that has been Gamma specifically tuned for either film, CRT (Cathode Ray Tube), Video, PC, or Bright Room input. (Film input is material originally captured on a film camera, like a movie; video input is material originally captured on a video camera, like a TV show or sporting event.) White Peaking increases the brightness of whites that are ne
ملخص المحتوى في الصفحة رقم 20
20 Color Space: this option applies to computer and Color space component video sources. It allows you to select a color space that has been specifically tuned for the input signal. When Auto is selected, the projector automatically determines the standard. To choose a different setting, turn off Auto, then choose RGB for computer sources, choose either REC709 or REC601 for component video sources. Color Temperature Color Temperature: changes the intensity of the colors
