ملخص المحتوى في الصفحة رقم 1
LCD Projector
MultiSync LT156/155/LT154
User’s Manual
ملخص المحتوى في الصفحة رقم 2
LIMITED WARRANTY (USA and Canada only) NEC SOLUTIONS’ PROJECTOR PRODUCTS HOW YOU CAN GET WARRANTY SERVICE NEC Solutions (America), Inc. (hereafter NEC Solutions) warrants 1. To obtain service on your product, consult the dealer from whom this product to be free from defects in material and workmanship you purchased the product. under the following terms. 2. Whenever warranty service is required, the original dated invoice (or a copy) must be presented as proof of warranty coverage. In order to o
ملخص المحتوى في الصفحة رقم 3
DECLARATION OF CONFORMITY This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. U.S. Responsible Party: NEC Technologies, Inc. Address: 1250 N. Arlington Heights Road Itasca, Illinois 60143 Tel. No.: (630) 467-5000 Type of Product: LCD Projector Equipment Classification: Class B Pe
ملخص المحتوى في الصفحة رقم 4
N T E R U N SELECT SOURCE AUTO ADJUST PC CARD ACCESS ON/ STATUS STAND BY POWER E M C A N C E L MultiSync LT156/LT155/LT154 LCD Projector User’s Manual English E – 1 E
ملخص المحتوى في الصفحة رقم 5
IMPORTANT INFORMATION Precautions RADIACION LASER REMOTE Please read this manual carefully before using your NEC MultiSync CAUTION NO MIRE AL RAYO CONTROL PRODUCTO LASER CLASSE2 MODEL: LT156/LT155/LT154 Projector and keep the manual handy for future LASER RADIATION- RD-367E LASER-STRAHLUNG DO NOT STATE INTO BEAM reference. 7N900012 NICHT IN DEN STRAHL WAVE LENGTH: 650nm BLICKEN ! LASER KLASSE2 Your serial number is located under the name plate label on the bot- MAX. OUTPUT: 1mW RAYONNEMENT LASER
ملخص المحتوى في الصفحة رقم 6
Important Safeguards Lamp Replacement These safety instructions are to ensure the long life of your projector •To replace the lamp, follow all instructions provided on page E-48. and to prevent fire and shock. Please read them carefully and heed all • Be sure to replace the lamp when the message "The Lamp has warnings. reached the end of its usable life. Please replace the lamp." appears. If you continue to use the lamp after the lamp has reached the end of its usable life, the lamp bulb may sha
ملخص المحتوى في الصفحة رقم 7
TABLE OF CONTENTS Setup ................................................................................... E-37 1. INTRODUCTION Orientation ..................................................................... E-37 Introduction to the MultiSync LT156/LT155/LT154 Projector ................. E-5 Background ................................................................... E-37 Getting Started ............................................................................. E-5 Mouse Settings .......
ملخص المحتوى في الصفحة رقم 8
1. INTRODUCTION 1 * Do not attempt to mount the projector on a ceiling yourself. Introduction to the MultiSync LT156/LT155/LT154 Projector The projector must be installed by qualified technicians in order to This section introduces you to your new MultiSync LT156 (XGA) / LT155 ensure proper operation and reduce the risk of bodily injury. In addi- (XGA) / LT154 (XGA) Projector and describes the features and con- tion, the ceiling must be strong enough to support the projector and trols. the inst
ملخص المحتوى في الصفحة رقم 9
N T E R U N SELECT SOURCE AUTO ADJUST PC CARD ACCESS ON/ STATUS STAND BY POWER E M C A N C E L OFF ON VIDEO S-VIDEO AUTO ADJ. RGB 1 RGB 2 PJ MENU LASER - + R-CLICK /CANCEL HELP POINTER PC CARD KEYSTONE MAGNIFY SLIDE FREEZE VOL. FOLDER PIC-MUTE SLIDE LIST Quick Connect Guide User's Manual What's in the Box? Make sure your box contains everything listed. If any pieces are missing, contact your dealer. Please save the original box and packing materials if you ever need to ship your MultiSync LT1
ملخص المحتوى في الصفحة رقم 10
N T E R U N SELECT SOURCE AUTO ADJUST PC CARD ACCESS ON/ STATUS STAND BY POWER E M C A N C E L Getting to Know Your MultiSync LT156/LT155/LT154 Projector Front/Side Features Controls Built-In Monaural Speaker (0.5W) Lens Remote Sensor Ventilation (inlet) One-touch Tilt Button Air Filter Adjustable Tilt Foot Zoom lever Focus ring Lens cap Attaching the lens cap to the lens hood with the supplied string and rivet 2. Use the rivet to attach the string to the bottom of the lens hood. 1. Thread th
ملخص المحتوى في الصفحة رقم 11
AC IN C CARD VIDEO S-VIDEO RGB AUDIO USB PC CONTROL E Rear/Side Features AC Input Connect the supplied power cable’s three- pin plug here. Ventilation (inlet) Remote Sensor Terminal Panel Slot for Kensington Micro Ventilation (outlet) saver Security System Rear Foot Bottom Rear Foot Rotate to fine-adjust horizontally position Lamp cover Spacer (black rubber) To fine-adjust the height of the rear foot, remove the spacer and rotate the rear foot to the Lamp cover screw desired height. E – 8 N T E
ملخص المحتوى في الصفحة رقم 12
C CARD VIDEO SV USB PC CONTROL E Top Features 4 8 9 1 2 3 5 6 10 7 1. Menu Button Displays the menu. 6. Auto Adjust Button (RGB only) Use this button to adjust Position-H/V and Pixel Clock/Phase for an 2. Select ▲▼ / Volume (+) (-) Buttons optimal picture. Some signals may not be displayed correctly or take ▲▼: Use these buttons to select the menu of the item you wish to time to switch between sources. adjust. When no menus appear, these buttons work as a volume con- 7. Power Button (ON / ST
ملخص المحتوى في الصفحة رقم 13
AC IN EO S-VIDEO DVI-D AUDIO LT156 C CARD VIDEO S-VIDEO RGB AUDIO USB PC CONTROL E Terminal Panel Features 8 7 6 5 4 3 2 9 1. Audio Input Mini Jack (3.5 mm ∅) 1 This is where you connect audio output from your computer, VCR, DVD player or laser disc player. A commercially available audio cable is required. 2. RGB Input/ Component Input Connector (Mini D-Sub 15 pin) 10 Connect your PC or other RGB equipment. Use the supplied RGB Slot for Kensington cable to connect to a PC. Or connect a Macintos
ملخص المحتوى في الصفحة رقم 14
3. LED Remote Control Features Flashes when any button is pressed. NOTE: If you are using a Macintosh computer, you can click either the right- click or left-click button to activate the mouse. 4. Power On Button If the main power is applied, you can use this button to turn your pro- NOTE: If any one of the buttons is pressed and held for 60 seconds or more, jector on. the button operations will cease to operate. This is not a malfunction, rather it is a feature used to prolong battery power. To
ملخص المحتوى في الصفحة رقم 15
EL PC CARD MAGNIFY SLIDE FREEZE VOL. FOLDER PIC-MUTE SLIDE LIST 15. Enter / Left Click Button 16. Cancel/ Right Click Button When you are in the Computer mode, this button works as the mouse When you are in the Computer mode, this button works as the mouse left button. right button. When you are in the Projector mode, which is indicated by lighting the When you are in the Projector mode, which is indicated by lighting the PJ button: PJ button: Use this button to enter your menu selection. It wor
ملخص المحتوى في الصفحة رقم 16
Remote Control Battery Installation Operating Range 1. Press firmly and slide the battery cover off. 7m 7m 30˚ 30˚ 30˚ 30˚ Remote Sensor Remote Control Precautions 2. Remove both old batteries and install new ones (AA). Ensure that • Handle the remote control carefully. you have the batteries' polarity (+/–) aligned correctly. • If the remote control gets wet, wipe it dry immediately. •Avoid excessive heat and humidity. • If you will not be using the remote control for a long time, remove the ba
ملخص المحتوى في الصفحة رقم 17
Using Remote Mouse Receiver The remote mouse receiver enables you to operate your computer's mouse functions from the remote control (Computer mode). It is a great convenience for clicking through your computer-generated presentations. To return to the Projector mode, press the PJ button (lit red). Connecting the remote mouse receiver to your computer To use the remote mouse function, connect the remote mouse receiver to your computer with one of the remote mouse cables (USB, PS/2 or Mac ADB). C
ملخص المحتوى في الصفحة رقم 18
Switching operation mode between mouse and projector The three shaded buttons shown on the drawing work as a computer mouse in the Computer mode. In the Computer mode the PJ button is not lit. • When the MENU button is pressed, the PJ button lights red to indicate that you are in the Projector mode, which allows the projector menu operation using the three buttons. • When the POINTER button is pressed, the PJ button lights red to indicate that you are in the Projector mode and that the MOUSE
ملخص المحتوى في الصفحة رقم 19
Screen WIDE: 300" 609.6 (W) X 457.2 (H) / 240 (W) X 180 (H) Screen size (Unit: cm / inch) 548.6 (W) X 411.5 (H) / 216 (W) X 162 (H) 270" 487.7 (W) X 365.8 (H) / 192 (W) X 144 (H) 240" 406.4 (W) X 304.8 (H) / 160 (W) X 120 (H) 200" 304.8 (W) X 228.6 (H) / 120 (W) X 90 (H) 150" 243.8 (W) X 182.9 (H) / 96 (W) X 72 (H) 120" 203.2 (W) X 152.4 (H) / 80 (W) X 60 (H) 100" 162.6 (W) X 121.9 (H) / 64 (W) X 48 (H) 80" 121.9 (W) X 91.4 (H) / 48 (W) X 36 (H) 60" 81.3 (W) X 61.0 (H) / 32 (W) X 24 (H) 40" 27"
ملخص المحتوى في الصفحة رقم 20
Distance Chart Throwing Distance (C) Screen top B=Vertical distance between lens center and Screen center screen center B C=Throw distance Throwing Angle (α) D=Vertical distance between lens center and Lens Center 1.6” (40.3mm) screen bottom (screen top for ceiling installa- D tion) Projector Foot Screen Bottom Ceiling Installation WARNING Screen top • Installing your projector on the ceiling must be Projector Foot done by a qualified technician. Contact your NEC D dealer for more information. 1
