ملخص المحتوى في الصفحة رقم 1
TEW-610APB
Quick Installation Guide
Version 8.19.2005
TRENDnet
TRENDware, USA
What's Next in Networking
Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
ملخص المحتوى في الصفحة رقم 2
Table of Contents English ...................................................................................................... 1 1 1. Prepare for Installation ...................................................................... 2. Install Hardware ................................................................................ 2 3. Configure TCP/IP Settings ................................................................ 3 4. Configure the Access Point .................................
ملخص المحتوى في الصفحة رقم 3
English QIG 1. Prepare for Installation Thank you for purchasing TRENDnet's TEW-610APB 108Mbps 802.11g MIMO Wireless Access Point. This guide will help you set-up your Access Point quickly and easily. Just follow the step-by-step instructions below, and enjoy the benefits of accessing the Internet/network without ever being tied down to wires! If you run into problems, please refer to the Troubleshooting section. If you need further technical support, please visit www.TRENDNET.com or cal
ملخص المحتوى في الصفحة رقم 4
2. Install Hardware 1. Locate an optimum location for the Access Point. The best place for the Access Point is usually at the center of your wireless network. 2. Connect the RJ-45 network cable to the Access Point, then connect the other end of the network cable to a Switch or Hub. The Access Point is now connected to your 10/100Mbps network. 3. Connect the power adapter to the Access Point. Make sure you use the power adapter supplied with the Access Point; using a different power adapter m
ملخص المحتوى في الصفحة رقم 5
3. Configure TCP/IP Settings Before the Access Point can be accessed and configured, the computer's TCP/IP settings need to be changed. (That includes your wireless card's IP address, too.) Windows 2000/XP 1. Find the Start button located on the Desktop. 2. Click Start, and click on Control Panel. For Windows 2000, click Start, highlight Settings, and click Control Panel. 3. Double-Click the Network Connection icon. 4. Right-Click on the Local Area Connection icon, then click on Properties.
ملخص المحتوى في الصفحة رقم 6
6. Click on Use the following IP address. Enter 192.168.0.50 for IP address and 255.255.255.0 for Subnet, and click OK. 7. Click OK. 8. Your computer is now ready to access and configure the Access Point. 4 English
ملخص المحتوى في الصفحة رقم 7
4. Configure the Access Point From a Wired Computer 1. Open a web browser (Internet Explorer or Netscape) and enter http://192.168.0.100 at the address bar, then press the Enter key. Type admin for username, and type admin for your password. Click OK. 2. Click admin and scroll down to the IP Settings section. Change the default IP address, subnet mask, and default gateway to match your current network settings. Your default gateway's IP address should be your router's IP Address. Type
ملخص المحتوى في الصفحة رقم 8
5. Configure your Wireless Network Adapter In this example, the TEW-601PC Wireless Utility will connect to the TEW-610APB. 1. Double-click the wireless computer icon in your system tray (next to the clock in the bottom right corner of your screen). 2. Click Site Survey, click Refresh, and select the desired access point. Click Connect. 3. Click OK. 4. Please verify your connection status. Congratulations! Installation is now complete. 6 English
ملخص المحتوى في الصفحة رقم 9
Troubleshooting Q1: I specified the IP address http://192.168.0.100 in my Internet browser's address bar, but error message says "The page cannot be displayed". How can I get into the TEW-610APB's web configuration page? A1: Please check your hardware and TCP/IP settings again by following the instructions sections 1~3, make sure the Power, LAN, MIMO on the Access Point's front panel are on and the TCP/IP configurations are correct. then try accessing http://192.168.0.100 again. Q2: If my
ملخص المحتوى في الصفحة رقم 10
TRENDnet TRENDware, USA What's Next in Networking Product Warranty Registration Please take a moment to register your product online. Go to TRENDware’s website at http://www.TRENDNET.com @ TRENDnet Technical Support US/Canada Support Center European Support Center Contact Contact Telephone: 1(310) 626-6252 Telephone Fax: 1(310) 626-6267 Deutsch : +49 (0) 6331 / 268-460 Français : +49 (0) 6331 / 268-461 Email: support@trendnet.com 08-00-90-71-61 (numéro vert) Tech Support Hours
