Makita 24016 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

255mm(lO") MODEL 24016
355mm(14") MODEL LS1410
INSTRUCTION MANUAL
Miter Saw & Standard Equipment
I.
0 Elbow (Dust Spout) @ Operating Handle (Switch) 8 Turn Base
A
@ Locking Stopper @ Motor Housing Miter Scale & Pointer
@ Fence @ Safety Cover 'ii, Miter Clamp Grip
0 Base @ Saw Blade @ Socket Wrench
DOUBLE
INSULATION
SPEC1 FICATIONS
__
520 mm x 480 mm x 460 mm 22 5 kg 15 m
12mmrll2mm 72mmr90mm 4,100
24010 2F:oqm I7 112"l x 14-314"l 12 112"l x 13-112"l Rlmm 120.1/21 x 118-1/8"1 x 11

ملخص المحتوى في الصفحة رقم 2

PRELIM IN AR Y I NST R UCTl ONS Your electric tool is precision built and manufactured to satisfy the highest standards. For maximum BEFORE CONNECTING YOUR TOOL performance, long tool life, and your safety, follow these instructions carefully. TO A POWER SOURCE VOLTAGE WARNING : Before connecting the tool to a power source (receptacle, outlet, etc.1 be Be sure you have read all sure the voltage supplied is the same as that specified on the nameplate of the tool. A power source with volta

ملخص المحتوى في الصفحة رقم 3

2. Installing Saw Blade 5. Miter Angle Setting Press the shaft lock and use the socket The saw blade should be in the fully raised wrench provided to loosen the hex bolt position before you change the miter angle. which serves to hold the saw blade in place. Release the miter clamp grip by turning Then remove the outer flange and install one-half a turn to the left (counterclock. the saw blade on the arbor shaft inside the wise), then push the grip in the direction of safety cover.

ملخص المحتوى في الصفحة رقم 4

8. Tips on Cutting 11. Saw Blade for Aluminum Applications (For Model 2401B only) This tool is equipped with an electric safety brake which stops the saw blade within Apply oil to the miter saw blade (No. 255-4A) for aluminum cutting, since without it three seconds from the moment you release the switch in the operating handle. This chips will adhere and the cutting edges will deteriorate. Apply oil near the arbor at the safety feature can also be used to advantage, for example, in cutting

ملخص المحتوى في الصفحة رقم 5

/ Saw Blades Chisel tooth combination saw blade For rip and cross-cut work. Most freauentlv used for general carpentry. NO. DM lmml di:Y&l ,r:h Part No. Far Model __- 255-7 2551 10' I 2511,,1 7214074 24018 260 110.114"1 36 721411-3 260 - 7 Miter saw blade For smooth cutting of wood. No. 255 - 4 i N-q. 255 - 4A For smooth cutting of aluminum. 7214040 255-4 2551 10'' I 2511"l 100 1 7214058 1 2401e 255 -4A Carbide-tipped saw blade Faster, smoother, longer sawing without blade