ملخص المحتوى في الصفحة رقم 1
IPRD SERIES OWNER’S MANUAL
IP SERIES In-Ceiling Speakers
IPRD6.5 / IPRD6.5ST / IPRD8
IPRD8 Speaker
OWNER’S MANUAL
Introduction
Thank you for your purchase and welcome to the growing community of satisfied OMAGE listeners. Please read the
following installation and operation guidelines carefully to ensure enjoyment of your custom installed home audio system,
for years to come. All OMAGE speakers should be set-up and installed by authorized and duly licensed technicians.
Your OMAGE IN-PERFORMA
ملخص المحتوى في الصفحة رقم 2
IPRD SERIES OWNER’S MANUAL Features and Benefits Your OMAGE IN-PERFORMA speakers are designed to blend seamlessly into your home interior while providing superior sound quality. Installation All OMAGE IN-PERFORMA products feature a self-engaging mounting system that does not require brackets. Simply cut a hole in the mounting surface, then remove the grille from the frame. Then tighten the four or six mounting “dogs” using the front panel screws. The dogs will automatically rotate 90 degrees
ملخص المحتوى في الصفحة رقم 3
IPRD SERIES OWNER’S MANUAL IP Series Speaker Installation Guide At OMAGE, we continuously strive to improve our products. For this reason, we reserve the right to change product specifications without notice. The information concerning product specifications and instructions in this manual do not necessarily set forth all technical or other specifications of OMAGE products. Additional information can be obtained on-line at www.omageusa.com IP Series Speaker Placement With OMAGE., realizing m
ملخص المحتوى في الصفحة رقم 4
IPRD SERIES OWNER’S MANUAL WIRE GAUGE AND QUALITY The total wire resistance should be less than 10% of the speaker impedance. If using an 8 ohm speaker, your total wire resistance be no more than 0.8 ohms. in simple terms, the extra resistance from the wire will have a very negative effect on the sound quality of the speaker. The sound can be less dynamic, definition of bass frequencies can be reduced, and in extreme cases, the high frequencies can be attenuated. Amplifier power is also wasted
ملخص المحتوى في الصفحة رقم 5
IPRD SERIES OWNER’S MANUAL Pre-Construction Brackets Pre-construction brackets are available with all OMAGE IPRD Series custom installed speakers. These brackets are measured to fit standard 16’’/24’’ wood stud intervals. 1. Nail or Staple the pre-construction brackets to the stud in the planned speaker position. With the flange of the speaker cut out facing out. 2. As the drywall installer is working, they can accurately cut-out the necessary hole for your speaker reducing installation tim
ملخص المحتوى في الصفحة رقم 6
IPRD SERIES OWNER’S MANUAL Existing Construction 1. Cut the appropriate size opening in the wall using the cutout template provided. Be careful not to cut through any existing wiring or plumbing. Note: Avoid compromising any fire stops between studs. 2. Run wiring to the wall opening(s). Be sure to comply with any codes that may apply in your area. PAINTING THE SPEAKERS AND GRILLES Speaker baffle and grilles can be painted before installation, which will eliminated the “paint scar” if the spe
ملخص المحتوى في الصفحة رقم 7
IPRD SERIES OWNER’S MANUAL IP SERIES The IPRD6.5, IPRD6.5ST and the IPRD8 speakers use the same installation directions as all OMAGE IN-PERFORMA speakers. Please pay close attention to the wiring of the speakers. The single in-ceiling series produces the left and right audio signal from one speaker. The crosover on the back of the speaker, shown below features two pairs of push-to- connect gold terminals. Attach the wire from your amplifier to the terminals on the back of the speaker. Double ch
ملخص المحتوى في الصفحة رقم 8
IPRD SERIES OWNER’S MANUAL IP Series In-Ceiling Speaker Specifi cations IPRD6.5 6.5” In-ceiling Speaker Woofer: 6.5” Woven Kevlar cone, rubber surround, 18oz Magnet, 1” voice coil, Bumped back plate, vented pole piece Tweeter: 1” Titanium Dome tweeter, Ferro-fl uid cooled, Neodymium magnet, Swivel 30 degrees Crossover: Phonalic PCB board, 18dB woofer section, 18dB tweeter section, polymide auto protective reset switch for tweeter Attenuation switches: ± 3dB on woofer and tweeter Frequenc
ملخص المحتوى في الصفحة رقم 9
IPRD SERIES OWNER’S MANUAL IPRD8 8” In-ceiling Speaker Woofer: 8” Woven Kevlar cone, rubber surround, 25oz Magnet, 1.25” voice coil, Bumped back plate, vented pole piece Tweeter: 1” Titanium Dome tweeter, Ferro-fl uid cooled, Neodymium magnet, Swivel 30 degrees Crossover: Phonalic PCB board, 18dB woofer section, 18dB tweeter section, polymide auto protective reset switch for tweeter Attenuation switches: +/- 3dB on woofer and tweeter Frequency response: 45Hz~22KHz Sensitivity: 89dB Reco
ملخص المحتوى في الصفحة رقم 10
IPRD SERIES OWNER’S MANUAL Warranty OMAGE USA Limited Warranty OMAGE USA warrants this product to the original purchaser to be free from defects in materials and workmanship (subject to the terms set forth below), for a period of five (5) years from the date of purchase. OMAGE USA will repair or replace (at OMAGE USA option) this product or any defective parts. Your authorized OMAGE USA dealer will inspect the product and, if your dealer is not equipped to perform the repair of your OMAGE U
ملخص المحتوى في الصفحة رقم 11
IPRD SERIES OWNER’S MANUAL Name: __________________________________________________________________________________ Street Address: _______________________________________________ Zip: ________________________ City & State: _____________________________________________________________________________ Home Phone: ____________________________________________________________________________ Work Phone: _____________________________________________________________________________ e-mail Address: _
ملخص المحتوى في الصفحة رقم 12
IPRD SERIES OWNER’S MANUAL In Canada In the United States OMAGE USA Corp. P.O. Box 124, OMAGE USA Corp. 5645 rue Paré Montgomery Center; Vermont, 05471 Montréal, Qc H4P 1S1 12
