ملخص المحتوى في الصفحة رقم 1
APS 25
MULTI-PURPOSE / MULTI-FUNCTION POWERED SPEAKER SYSTEM
APS 25 SPECIFICATIONS USER’S GUIDE
Rated Power 20 watts continuous
Frequency Response 65Hz – 18kHz
M ax SPL @ rated output 101dB @ 1 m eter
W oofer 5.25" (133.35m m ) high efficiency
magnetically shielded
Tweeter 1" (25m m ) dom e
st
Crossover 1 order passive @ 8kHz
Tone Control -6dB/octave sliding lowpass (3kHz to 8kHz)
W ireless inputs 2 user-installable receivers
VHF (169-213M Hz) – 30 fixed
UHF (794-806M Hz) – 63
ملخص المحتوى في الصفحة رقم 2
Warning: To prevent shock hazard do not open or remove speaker/speaker grill. 4. Power Cord Protection - Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying (5) 3-Position Switch particular attention to cords at plugs or convenience re- left position:OFF - Middle position:STANDBY - Right position:ON ceptacles. 5. Ventilation - A metal heatsink is provided for heat dis- In the “STANDBY” position, the audio is mute
ملخص المحتوى في الصفحة رقم 3
(7) Level: Introduction Turn clockwise to increase, or counterclockwise to decrease the input level. Congratulations. You have chosen one of the most versatile powered A small screwdriver is supplied to make adjustments. The level control is ® loudspeaker systems on the market today. The Azden APS 25 is a so- factory-preset in the center position. phisticated 4-channel mixable speaker system that allows you to utilize two different wireless inputs in addition to a wired microphone and a line- NO
ملخص المحتوى في الصفحة رقم 4
31XT Plug-in transmitter adaptor: Note:The 31XT is designed to turn any wired dynamic metal-body microphone that has an XLR output into a wireless microphone. Connecting the 31XT: Disconnect the microphone cable from the microphone by pushing down on the release button where the microphone and cable connect. Connect the 31XT by 1 lining up the pins on the microphone with the holes on the transmitter, and insert. Push the 31XT into the microphone until it locks into place. Removing the 31XT: Pus
ملخص المحتوى في الصفحة رقم 5
(6) 3-Position Switch Installing an APS module... (see photo - page 1) Left position:OFF - Middle position:STANDBY - Right position:ON All APS modules install into the APS 25 in the same manner. To In the “STANDBY” position, the audio is muted. install, first remove the blank panel by loosening the two retaining thumb screws. Next remove the “shorting board” by pulling it straight out. Now, (7) LED Indicator simply slide the module into the slot and lightly press until the connector RED when swi
ملخص المحتوى في الصفحة رقم 6
7. LINE IN - this mono RCA jack is designed to accept audio from Using an APS VR module and VHF Transmitter(s)... devices such as CD players, video tape players or anything else with The APS VR receiver module comes pre-adjusted to one of 30 dif- a line-level audio output. The input volume is controlled by the LINE ferent VHF frequencies between 169MHz and 213MHz. The particular LEVEL knob (6). frequency(s) you have were chosen to not interact/interfere with TV sta- 8. LINE OUT - this mono RCA j
