DCM Speakers DCM12 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

21A3887
TEN YEAR LIMITED WARRANTY
DCM Enclosed Loudspeaker Systems are guaranteed against defects in parts
and workmanship for a period of ten (10) years from the date of purchase.
Speakers found defective during that period will be repaired by DCM without
charge for parts.This warranty extends to the original purchaser from an author-
ized DCM retailer only.
This warranty does not extend to equipment damage due to negligence, mis-
use, improper installation, shipping damage, abuse or accident.T

ملخص المحتوى في الصفحة رقم 2

INTRODUCTION CARE AND MAINTENANCE Congratulations on your purchase of DCM Loudspeakers. Your new speakers represent the latest technologies in loudspeaker design and manufacturing. They Your speakers are designed to work with a wide range of electronic components. will provide outstanding performance and years of listening enjoyment. Please As little as 20 watts per channel can provide enough power for most applications. take time to read through this manual thoroughly to insure you get maximum

ملخص المحتوى في الصفحة رقم 3

should be spaced equal distances from the listening position with the tweeters at SPECIFICATIONS or above ear level. DCM6 Driver Compliment Woofer- 6-1/2” polypropylene cone with pole mounted phase plug Tweeter- 1.8kHz constant directivity Horn Loaded CENTER Frequency Response: 58Hz - 20kHz CHANNEL LEFT RIGHT Impedance: 8 ohms nominal FRONT FRONT Power Handling: 75 watts RMS / 150 watts total Sensitivity: 89dB 1W/1m Shipping Weight: 17.0 lbs. / 7.7kg Dimensions: 12.992” H x 7.992” W x 7.795” D

ملخص المحتوى في الصفحة رقم 4

CENTER CHANNEL HOOK UP DCM6C Use 16 gauge or heavier speaker wire for connecting to your amplifier or receiv- When using the DCM6C as a center channel speaker in a home theater applica- er. Cut wire lengths leaving an extra 12” to 24” at each end to allow for moving tion the following guidelines should be used for optimum performance. the speaker or receiver. Locate the speaker as close to the center of your TV or monitor as possible Using a wire cutter or a sharp knife, strip 1/2” of insulation