Swann 1060 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Help Desk / Support Details
English
All Countries E-mail: tech@swann.com.au
Telephone Helpdesk
UNITED STATES toll free
1060 Camera Housing
877-274-3695
(Sun-Thurs, 2pm-10.30pm PST)
All Weather Camera Protection
800-627-2799
(Mon-Fri, 9am-1pm PST)
with inbuilt heater / blower
USA Exchange & Returns
562-777-2551
(Mon-Fri, 9am-4pm PST)
AUSTRALIA toll free
1300 13 8324
(Mon-Fri, 9am-5.30pm Aus EST)
International
+61 3 8412 4610
(Mon-Fri, 9am-5.30pm Aus EST)
See http://www.worldtimeserver.com for inf

ملخص المحتوى في الصفحة رقم 2

Mounting the 1060 Housing INDEX 2 2 Introduction Using the built in adjustable 2 2 This package comes with... mounting points you can mount the 3 3 Opening the 1060 Housing 1060 Housing on a stand, pole or 4 4 Installing a Camera wall bracket. For alternative 5 5 Connecting your Camera mounting options, the Universal Tilt 6 6 Connecting the Heater / Blower Power and Swivel stand is available for 7 7 Mounting the 1060 Housing separate purchase. Product code 7 7 Technical Specifications SW-A-CBI.

ملخص المحتوى في الصفحة رقم 3

Connecting the Heater / Blower Power Opening the 1060 Housing Connect the wires you Turn the 1060 Housing upside-down and then passed through the seal using a “Philips Head” screwdriver, loosen the plug to the Heater / two screws at the side of the 1060 housing until Blower power terminals the top of the casing can be lifted towards the with the positive and opposite side of the housing. negative wires as marked in this illustration. Once the wires are in the screw terminal holes, + - + - tighte

ملخص المحتوى في الصفحة رقم 4

Installing a Camera Connecting your Camera Insert the cables for Fit your CCTV camera to the the Camera Power, camera mounting plate Camera Video and using the supplied mounting Heater / Blower screw or the screws that may through the seal plug have come with your on the underside of camera the back end of the 1060 housing and pass the cables - + through in to the housing. Once this is done tighten the nuts on the seal to prevent moisture and dust entering. Fit the camera mounting plate back int