BeachTek DXA-10 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Specifica tions
Gain Switchable: HI (60 dB); LO (30 dB)
Frequency response 20 Hz to 20 KHz, -1 dB
THD + N Less than 0.03% @ 1 kHz,

DXA- 10
Signal-to-Noise ratio 90 dB @ -10 dBV output
Maximum output level +18 dBV (RCA output) Operating Instructions for the DXA-10
-37 dBV (MIC output)
Stereo Microphone Preamplifier

Phantom power Dual regulated 48 volt power
supplies
Current to 14 mA (direct short)
Battery type / duration One standard 9 volt alkaline
battery

ملخص المحتوى في الصفحة رقم 2

Front Panel Controls and Indicators Rear Panel Controls and Connections 1. Power 5. Balanced and Unbalanced Input Connections Install a fresh 9 volt battery in the adapter. Turn on the PWR switch The XLR inputs of the DXA-10 can accept balanced or unbalanced to activate the unit. The LED above the switch should light to indicate connections. To convert the input to unbalanced, simply ground good battery power. Turn off power when not in use to conserve pin 1 to pin 3. ba