Xantech BXAUDIO4X4 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

QUICK PROGRAMMING GUIDE

MODEL BXAUDIO4X4
FOUR ZONE – FOUR SOURCE
COMPLETE AUDIO CONTROLLER/AMPLIFIER SYSTEM
[Complete Programming Instructions can be found in the Installation Instruction Manual]





























Programming Button Layout

PROGRAMMING KEYPAD BUTTONS (SINGLE COMMANDS)
Note: When learning IR commands into the BXAUDIO4X4 Controller, make sure the IR Learning eye is free from IR
interference that might result in IR learning error o

ملخص المحتوى في الصفحة رقم 2

13. Repeat Steps 3 through 12 for Sources 2 through 4. 14. BXAUDIO4X4 Controller will need to be power cycled for commands to take effect. PROGRAMMING KEYPAD BUTTON WITH A SEQUENCE OF COMMANDS All programmable buttons on the BXAUDIO4X4 Keypad can be programmed to send IR sequences of up to 5 commands. 1. Program a single IR command on a keypad button following steps 1 through 7 as outlined in the section above. 2. Press the SEQUENCE [7] button located on the front of the BXAUDIO4X4. a.