Chamberlain RWA300R دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

®
Model RWA300R
Wireless Pedestrian & Vehicle Alert
Overview
The Alert uses a Passive Infra-Red sensor to detect To prevent possible SERIOUS INJURY or DEATH from
electrocution, outputs are suitable ONLY for controlling low
movement of people and vehicles, while allowing
voltage devices, 24V max, ac or dc.
small animals to pass through undetected.
Carton Inventory
Battery: The AA batteries (not provided) in the PIR
Motion Sensor will last up to 2 years depending on
use (Lithium batteries rec

ملخص المحتوى في الصفحة رقم 2

PIR Motion Sensor Assembly & Test Step 3 Step 1 Insert battery pack facing away from circuit board and Attach PIR Motion Sensor box to mounting plate with attach cover. large silver screw. Tighten screw until PIR Motion NOTE: Ensure the batteries do not touch the circuit Sensor stays in place when repositioned. board and the antenna and battery wires are not pinched. Step 2 Step 4 Install 4 AA Alkaline batteries (not provided). (Lithium batteries recommended for colder environments.) Tes

ملخص المحتوى في الصفحة رقم 3

Programming PIR Motion PIR Motion Sensor Installation Sensor to Base Station Step 7 Step 5 Mount PIR Motion Sensor horizontally on solid surface a few feet off the ground and within 900' of Base Station (rotate sensor to access screw holes). Unit should be OPTIONAL A able to swivel as needed. Attach sun/rain shield. NOTE: Keep PIR Motion Sensor antenna away from metal objects. Do not mount PIR Motion Sensor in direct sunlight, near moving tree branches, or in the path of a sprinkler sys

ملخص المحتوى في الصفحة رقم 4

Troubleshooting The PIR Motion Sensor lights up, but the Base The Alert is giving false alarms. Station does not respond. Check for moving tree branches or insects in sensor The PIR Motion Sensor must be programmed to Base window. PIR sensor can also be triggered by light Station (See Step 6). shining directly in sensor window, such as reflected Ensure Base Station is on and is not muted. sunlight, or motion in front of a light source. If the green power light is not lit or is flashing, press