Crestron electronic Closed-Loop Photocell Light Sensor GLS-LCL دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Crestron GLS-LCL
DESCRIPTION
CLOSED-LOOP PHOTOCELL LIGHT SENSOR
Operations & Installation Guide
The GLS-LCL Closed-Loop Photocell responds to ambient light
levels within an occupied space and provides an analog voltage
proportionate to the ambient light level.
The ambient light measured is the light from any light source in the
visible spectrum. The photocell does not distinguish between natural
sunlight and artificial light. It contains a sensor which is color and
spatially corrected to pr

ملخص المحتوى في الصفحة رقم 2

INSTALLATION (Continued) TYPICAL APPLICATION DIAGRAMS 3. Prepare the photocell lead wires by removing 3/4" (1.9 cm) of insulation from each lead to expose bare copper wire. Make sure the ends of wires are straight. 4. Determine the length of low voltage wires needed to connect power to photocell. Use wires suitable for low-voltage wiring according to local electrical codes. 5. Route low-voltage wires from GLS-LCL location(s) to interface device location(s). (Refer to the wiring diagrams in