Eagle Tree Systems GFORCE-HIGH دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Instruction Manual for the 3 Axis G-Force MicroSensor

Model Numbers: GFORCE-LOW, GFORCE-HIGH
Document Version 1.2

Thank you for your purchase! This instruction manual will guide you through the installation and operation of your G-Force MicroSensor
(the G-Sensor). The latest version of this manual is available in the Product Manuals section of the Support tab on
http://www.eagletreesyste

ملخص المحتوى في الصفحة رقم 2

Page 2 If you have the High G sensor, and wish to measure vertical force greater than 8 g, you can mount the sensor so that either the X or Y axis is vertical. Range check: It is extremely unlikely that the installation of the G-Sensor will affect your model’s radio range or control. But, as always after making an electronics change to your model, it is very important that you range and function test your model once the G-Sensor is installed to ensure that there is no impact on your s

ملخص المحتوى في الصفحة رقم 3

Page 3 Note that the force of gravity is 1 g. So, when configured for 2 g, the MicroSensor will easily be triggered by normal handling. For example, lifting it at a rate that causes an additional 1 g of acceleration on the Z axis will trigger the sensor. Along these lines, it is important to handle the sensor with care when reading the last session’s maximum values or they could be lost and replaced. To change the G-Force trigger value, connect the Standalone Cable as descri

ملخص المحتوى في الصفحة رقم 4

Page 4 Troubleshooting Below is a list of problems that may be encountered, and steps to remedy them. If your particular issue is not addressed by the below, visit the Eagle Tree G-Sensor support thread at http://www.rcgroups.com/forums/showthread.php?t=1454098. Chances are someone has posted a solution to your problem already. If not, posting your problem there will get a very quick response from the Eagle Tree community. If you prefer to not post on the forum, or you feel there i