Metra Electronics GMLAN29-100 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION INSTRUCTIONS FOR PART GMLAN29-100
GMLAN29-100
*Read Important Warning On Page 1
Before Attempting Any Installation*
The GMLAN29-100 is designed to and MUST be used with the
GMOS-100i (SOLD SEPERATELY). Please refer to GMOS-100i
for 20 pin connector instructions
APPLICATIONS
BUICK GMC
Acadia 2007-10
Enclave 2007-10
Lucerne 2006-10 Savanna 2008-10
Sierra (New body) 2007-10
CADILLAC Yukon 2007-10
Escalade 2007-10
DTS 2006-10 HUMMER
H2 2008-09
SRX 2007-09
PONTIAC
CHEVROLET
Avalanche

ملخص المحتوى في الصفحة رقم 2

INTERFACE COMPONENTS •A) 4 pin harness with stripped leads •B) 22 pin to 30 pin GM harness •C) 16 pin backup camera harness •D) 16 pin RSE harness A B 4 pin C D TOOLS REQUIRED FOR INSTALLATION •Cutting Tool •Tape •Crimping Tool •Connectors (I.E. butt-connectors, bell caps, ECT…) M2.6 6 2.5 1.5 IGNITION TERMINALS WIRE CUTTER ISO M3.5 M4 M3 M5

ملخص المحتوى في الصفحة رقم 3

TABLE OF CONTENTS Installing The Interface .............................................................. 1 Installing The GMLAN29-100 ................................................. 1 Programming SWC ..................................................................... 2 Testing The GMLAN29-100 ...................................................... 2 KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics s

ملخص المحتوى في الصفحة رقم 4

*Important: Before beginning any of the following, disconnect the negative battery terminal to prevent an accidental short circuit. INSTALLING THE INTERFACE From the 22 way harness: • Connect the Black wire with the ring terminal to the back of the aftermarket radios chasis • Connect the 3.5mm jack to your aftermarket radios steering wheel control input (if equipped) From the 30 way harness: • Connect the Black wire to the ground wire of the aftermarket radio • Connect the RCA’s on the 8 p

ملخص المحتوى في الصفحة رقم 5

PROGRAMMING SWC • Turn on the ignition • The LED will begin to blink rapidly • Turn on the aftermarket radio • Press volume up until radio responses TESTING THE GMLAN29-100 • Turn the ignition on, and then turn the aftermarket radio on. • Push the Onstar button, the radio should turn off (radio will mute if mute wire is connected) and you should hear Onstar. Push the Onstar cancel button and the radio should come back on. 2

ملخص المحتوى في الصفحة رقم 6

NOTES

ملخص المحتوى في الصفحة رقم 7

NOTES

ملخص المحتوى في الصفحة رقم 8

INSTALLATION INSTRUCTIONS FOR PART GMLAN29-100 1-800-221-0932 axxessinterface.com © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION REV. 4/2/2010