ملخص المحتوى في الصفحة رقم 1
POWERTRIM
Code 407F
OWNER’S HANDBOOK
CODE SERIAL NO. PART NO: 111-3445 (Rev. A)
407F 310000001
Issue 10/2009
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS 3 LIMITED WARRANTY 4 OPERATOR SAFETY ASSEMBLY 8 OPERATION 11 MAINTENANCE 14 19 TROUBLESHOOTING 21 SPECIFICATIONS REPAIR PARTS 23 2 1739579
ملخص المحتوى في الصفحة رقم 3
LIMITED WARRANTY Hayter Limited warrants to the original user / purchaser that this unit shall be free from defects in material and workmanship under normal use and service for a period of three years from the date of purchase. The manufacturers of the engine and battery pack system (where applicable) furnish their own warranty and services are provided through their authorised network (Refer to “Engine/Battery Pack Warranty Statement”). To qualify for the full benefit of the warranty, the war-
ملخص المحتوى في الصفحة رقم 4
OPERATOR SAFETY 7. Wear appropriate clothing such as a OWNER’S INFORMATION long−sleeved shirt or jacket. Also wear Know your product: If you understand the long trousers. Do not wear shorts. unit and how the unit operates, you will get 8. Do not wear loose clothing or jewelry. the best performance. As you read this manu- They can be caught in moving parts. al, compare the illustrations to the unit. Learn 9. Always wear safety goggles or safety the location and the function of the controls. g
ملخص المحتوى في الصفحة رقم 5
OPERATOR SAFETY 21. Stop the engine whenever you leave the Do not trim on wet grass. Reduced footing equipment, before cleaning repairing or could cause slipping. inspecting the unit, be sure the trimmer head and all moving parts have stopped. Let the engine cool, disconnect the III. Children spark plug wire and move it away from Tragic accidents can occur if the operator is the spark plug. not alert to the presence of children. Children 22. If the equipment should start to vibrate are often att
ملخص المحتوى في الصفحة رقم 6
OPERATOR SAFETY 2. Never run the engine indoors or inside a 8. To reduce fire hazard, keep machine closed area. The exhaust fumes are free of grass, leaves, or other debris dangerous, containing CARBON MON- build−up. Clean up oil or fuel spillage. OXIDE, an ODORLESS and DEADLY Allow machine to cool before storing. gas. 9. Stop and inspect the equipment if you 3. Never make adjustments or repairs with strike an object. Repair, if necessary, be- the engine running. Disconnect the fore restarting.
ملخص المحتوى في الصفحة رقم 7
OPERATOR SAFETY INTERNATIONAL PICTORIALS IMPORTANT: The following pictorials are located on your unit or on literature supplied with the product. Before you operate the unit, learn and understand the purpose for each pictorial. 1 2 3 4 5 6 7 8 Safety Warning Pictorials 1 WARNING 5 WARNING: Rotating Parts. Stop Engine. Disconnect Spark Plug Wire Before 2 IMPORTANT: Read Owner’s Manual Making Adjustments. Before Operating This Machine. 6 WARNING: Wear Eye Protection 3 WARNING: Thrown Objects. Keep
ملخص المحتوى في الصفحة رقم 8
ASSEMBLY CONTENTS OF LITERATURE PACK 1 - Operator’s Manual 1 - Engine Manual 1 - Document of Conformity 1 - Warranty Card 1 - Safety Glasses 1 - Trimmer Line (2 Sets) 1 - Bag (4 Screws) REMOVE THE TRIMMER WARNING: Always wear safety glasses or eye shields while as- FROM CARTON sembling the machine. 1. Remove the parts bag and any loose parts from carton. 2. Remove the packing material positioned TOOLS REQUIRED around the unit. 1 − Knife to cut carton. 3. Cut down all four corners of the
ملخص المحتوى في الصفحة رقم 9
ASSEMBLY RAISE THE HANDLE 1. Hold the handle with one hand and loosen both handle adjustment knobs until the ratchet teeth are disengaged. Do not remove the handle adjustment knobs. See Figure 2. 2. Raise the handle to the operating position. 3. Stand in the operator’s Handle position behind the ma- chine. Put the handle in a comfortable position. Rope Make sure both sides of Guide the handle are level. NOTE: Make sure the cables are not caught Recoil Start between the upper and Handle lower h
ملخص المحتوى في الصفحة رقم 10
ASSEMBLY ENGINE PREPARATION Fill Crankcase With Oil 1. Remove the oil fill cap/dipstick shown in Note: Engine does not contain OIL or Figure 4. Fill the crankcase to the FULL PETROL. line on oil fill cap/dipstick. DO NOT OVER- FILL. WARNING: Follow the engine 2. Install the oil fill cap/dipstick and tighten manufacturer’s instructions for securely. the type of petrol and oil to use. Always use a safety petrol container. Do not smoke when adding petrol to the en- Fill Fuel Tank With Petrol gine.
ملخص المحتوى في الصفحة رقم 11
OPERATION KNOW YOUR POWERTRIM READ THE OWNER’S HANDBOOK AND ALL SAFETY RULES BEFORE YOU OPERATE the machine. To familiarise yourself with the location of the controls, compare the illustrations with your machine. Save this handbook for future reference. Control Bail Trimmer Head Drive Lever Upper Handle Throttle Control Lever Dipstick Recoil Starter Handle Debris Screen Handle Adjustment Knob Fuel Cap Trimmer Head Trimmer Line Shield Edge Guard Figure 5 Trimmer Head Drive Lever − Engages Throttl
ملخص المحتوى في الصفحة رقم 12
OPERATION USE THE TRIMMER HEAD DRIVE LEVER Control Bail 1. To engage the trimmer head, hold the con- Handlebar trol bail against the handle. Move the trimmer head drive lever forward to en- gage the trimmer head. See Figure 6. The faster the engine runs, the faster the trim- mer head will rotate. 2. Once the trimmer head is rotating, push the machine forward to trim. Trimmer Head Drive Lever Figure 6 USE THE THROTTLE CONTROL 1. During normal use, set the throttle con- trol lever in the FAST po
ملخص المحتوى في الصفحة رقم 13
OPERATION NOTE: If engine fails to start after three START THE ENGINE pulls, push the primer button two times and NOTE: DO NOT BE ALARMED, your engine again pull the recoil starter handle. will smoke the first time it is started. It is WARNING: Never run the engine burning off the protective coating that is on indoors or in a poorly ventilated the internal engine parts. area. Engine exhaust contains WARNING: Never leave the ma- carbon monoxide, an odorless chine unattended while the en- and dead
ملخص المحتوى في الصفحة رقم 14
MAINTENANCE SERVICE RECORDS Before Every Every Every Fill in dates as you Each 5 25 100 As SERVICE complete regular service. Use Hours Hours Hours Noted DATES Check Engine Oil Level √ Check Trimmer Lines 1 √ Check Trimmer Head √ Engagement Engine/Machine Cleaning 2 √ Check Nuts and Bolts √ Check Spark Plug √ Change Engine Oil √ Service Air Filter 3 √ Lubricate Jackshaft Assembly √ Lubricate Wheel Bearings √ Note 1 − When old line is half the original length, replace with new
ملخص المحتوى في الصفحة رقم 15
MAINTENANCE LUBRICATION Grease Fitting Lubricate the Jackshaft Assembly A grease fitting is provided to lubricate the jackshaft assembly. Use a grease gun with au- tomotive type grease to lubricate the jackshaft assembly as shown in Figure 10. Figure 10 Change Engine Oil Change the engine oil when the engine is 7. Connect the spark plug wire to the spark warm. For the proper oil capacity, see the en- plug. gine manufacturer’s instructions. 1. Disconnect spark plug wire from the spark Oil Drain
ملخص المحتوى في الصفحة رقم 16
MAINTENANCE SPARK PLUG Check the spark plug every 25 hours. Re- Tighten the spark plug to a torque of 15 place the spark plug if the electrodes are foot−pounds. pitted or burned or if the porcelain is cracked. 1. Make sure the spark plug is clean. Clean Feeler Gauge 0.030” the spark plug by carefully scraping the electrodes (do not sand blast or use a wire brush). 2. Check the spark plug gap with a feeler gauge. See “Product Specifications” for the correct spark plug gap and replace- ment spark
ملخص المحتوى في الصفحة رقم 17
MAINTENANCE SERVICE AND ADJUSTMENT WARNING: Before you inspect, clean or service the machine, stop the engine. Make sure that all moving parts have stopped. Disconnect the wire from the spark plug. PROPER CARE OF TRIMMER LINE For the best performance, use a heavy IMPORTANT: To extend the life of the trim- gauge 3.9mm (0.155” diameter) trimmer mer line, keep the trimmer line moist. If not line. Cut the length of the trimmer line to kept moist, the nylon trimmer line will be- 52cm (21.5 inches). D
ملخص المحتوى في الصفحة رقم 18
MAINTENANCE REPLACE THE DRIVE BELT To replace the drive belt, see an author- ized service center. STORAGE WARNING: Do not remove petrol Engine while inside a building, near a To prevent engine damage when the ma- fire, or while you smoke. Petrol chine is in storage for 30 days or more, fol- fumes can cause an explosion or low the steps below: a fire. Let the engine run until it is out of petrol. When the machine is put in storage for thirty Drain the oil from the warm engine. Fill the days or mo
ملخص المحتوى في الصفحة رقم 19
TROUBLESHOOTING CHART TROUBLE CAUSE CORRECTION Engine does not start. Spark plug wire Connect spark plug wire. disconnected. Engine not primed. Prime engine. Defective or incorrectly Inspect or replace spark gapped spark plug. plug. Fuel tank empty. Add fuel. Dirty carburetor or fuel line. Clean carburetor or fuel line. Dirty air filter. Replace air filter. Carburetor out of adjustment. See authorized dealer. Engine flooded. Wait several minutes before starting. Throttle control lever in Move
ملخص المحتوى في الصفحة رقم 20
TROUBLESHOOTING CHART Engine overheats. Engine cooling system See authorized dealer. clogged. Carburetor out of adjustment. See authorized dealer. Oil level is low. Add oil. Engine will not stop Defective throttle control See authorized dealer. running. lever or wire. Poor trimming Trimmer line length is too Correct line length is 52 cm performance. short. (21,5 inches). When less than 1/2 this length, replace the line. Move engine throttle lever to Trimmer vibrates. Engine not set at FAST FAST
