Extron electronic sWMK 100 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

WMK 100 Installation Notes
®
The Extron WMK 100 Wall Mounting Kit is used for hanging PoleVault System A/V products on a wall near
a flat screen display or short throw projector.
The WMK 100 has a 13" x 13" x 2.5" deep enclosure to mount the
PoleVault switcher and the power supply, with room for cable
management. It also has knockouts on all four sides which allow
external raceways to be used where necessary for cabling.
(4) 1/4-20 x 2"
Pan Head Bolts
Maximum load for the WMK 100 i

ملخص المحتوى في الصفحة رقم 2

WMK 100 Installation Notes, cont'd 1B. To mount the WMK 100 onto a non-masonry wall: WMK 100 Mounting Cutout for Marker for Base Plate Holes Signal Cable Level Pilot Hole i. At the desired site locate the wall studs and mark their Access locations. For ideal installation secure the base plate to at least one N wall stud (see figure 3). Drywall Kap toggles can be used for holes not aligned with studs. The base plate can be installed over an existing electrical outlet. The opening fits s

ملخص المحتوى في الصفحة رقم 3

3. Run cables 700 Run signal cables from the proposed PoleVault input wall plates, 2400 control device location, and the speakers to the WMK 100 location. Cables can be routed behind the walls, or through a surface raceway Raceway Option (e.g., Wiremold 700 or 2400 series) directly to the WMK 100. 3A. If running cable behind the walls: i. Run all the cables from the various locations to the WMK and through the access hole. 3B. If using a surface raceway: i. Attach the WMK cover to the b

ملخص المحتوى في الصفحة رقم 4

WMK 100 Installation Notes, cont'd 5. Final installation. a. After completion of cabling, place the cover over the installed plate, and secure at each corner with the provided 6-32 button head screws. N Ensure any cables exiting the box (e.g., to display device and external electrical outlet) pass through a raceway knockout. b. Switch on the display device, control device, signal sources and adjust and configure the system as needed. For full configuration and setup details, refer to the Po