Atdec TH-1026-VTP دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

TH-1026-VTP
Installation Instructions
Flat Screen Wall Mount | Tilt
Component Checklist
HARDWARE
M4x10mm/16mm
M6 Coach
M4/M6 Washer
Bolt (x4) (x4 each)
Spanner
Tools Required:
M6x10mm/16mm
• Power Drill
• 4mm(0.15”) Drill Bit
• 8mm(0.3”) Masonry Drill Bit
Display Mounting
TH-1026-VTP
S8 Nylon
Security
• Phillips head screw driver
Screws (x4 each)
(fully assembled)
Anchor (x4) Screw (x2)
• 17mm(0.7”) Socket Wrench or Shifter
IMPORTANT INFORMATION:
! IMPORTANT - Install Telehook Flat Screen

ملخص المحتوى في الصفحة رقم 2

Step 4. Remove Mounting Plate Step 5. Attach Mounting Plate to the Display Mounting Plate Display Mounting Screw PULL-OUT TOP Washer Mounting Plate Back of Display Step 6. Mount the Display to the Wall Step 7. Fasten the Two Security Screws DISPLAY NOT SHOWN DISPLAY NOT SHOWN Mounting Plate with Display INSERT FASTEN Security Screw Step 8. Tilt Adjustment Step 9. Pan Adjustment DISPLAY NOT SHOWN DISPLAY NOT SHOWN -15° +15° -30° TIGHTEN LOOSEN +30° Installation Complete No portion of this docu