Xantech 28EXT دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

28EXT External Emitter Adapter

INSTALLATION INSTRUCTIONS

DESCRIPTION
The 28EXT External Emitter Adapter is placed between a Xantech IR system and a list of approved
electronic equipment that feature a rear panel IR input jack. These input jacks accept electrical IR
commands without the carrier frequency, and are therefore not compatible with full range IR Receivers that
output a carrier frequency along with the IR commands, such as all Xantech IR Receivers. The 28EXT
interfaces and

ملخص المحتوى في الصفحة رقم 2

TABLE A (continued): APPLICATION #5 – VERIZON® FiOS™ MOTOROLA® RECEIVERS Model: TIP +5VDC Power QIP7000 Series RING SIGNAL SLEEVE GROUND Connector marking: IR RECEIVER INPUT Wire-Swap Connector Required CONNECTIONS • Connect the 28EXT output, using the Wire-Swap Connector if required, to the equipment’s IR input. • Connect the 28EXT input to a Xantech IR system’s connecting block. The yellow plug should connect to the yellow connector (emitter connection). TABLE B: