Fantech RE دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

RE41999R
SERIES
RE
1712 Northgate Blvd-Sarasota, FL. 34234
INSTALLATION & MAINTENANCE
Phone: (800) 747-1762 Fax: (800) 487-9915
INSTRUCTIONS
Phone: (941) 351-2947 Fax: (941) 359-3828
Web Site: www.fantech-us.com
Read and Save These Instructions !
INSTALLATION
DO NOT CONNECT POWER SUPPLY until fan is completely installed. Make
1. The compactness and adaptability of
sure electrical service to the fan is locked in “OFF” position.
Models RE fans permit easy
installation. T

ملخص المحتوى في الصفحة رقم 2

Dimensions A RE(C) 6 RE(C) 8XL RE(C) 10XL A 13.07 15.75 19.76 B 6.50 6.00 11.75 C 6.00 8.00 10.00 D 15.50 20.00 20.00 E 15.50 20.00 20.00 B **Dimensions in inches** NOTES: C 1. Add 1.5 inches to “B” when using curb. 2. All units provided with 7/8" knockout. 3. All units come with conduit and fittings. D Model RE with flat base Model REC for curb mounting E SPECIFIC INSTALLATION INSTRUCTIONS Suitable sealing such as tar or similar material (n

ملخص المحتوى في الصفحة رقم 3

aaaaaaa For installations in which the fan is connected to a range hood, or if an exhaust grille connected to the fans is located above or near the cooking surface, as shown below, be sure to observe the following safety warnings: CAUTION CEILING WARNING a TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK. COOKING AREA ( Use only galvanized steel ductwork. ) Use only galvanized steel ductwork in accordance with all applicable codes. OO 45

ملخص المحتوى في الصفحة رقم 4

WIRING DIAGRAMS SPECIAL WIRING PRECAUTIONS All installation should be wired according to the following diagrams. Failure to comply will cause the motor to “hum” or not work. 1. Turn off power at service entrance before wiring this fan. 2. Read the fan data plate to determine the current draw. Check that available supply is suitable . 3. Remove top enclosure of fan and the wiring box lid. A 7/8” hole is provided for electrical service entry. Use connectors and conduit provided