Audiovox 50-0246x-015 Series دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

FOR
50 - - 015 SERIES 1181270























of product during instal



Mat

4. 1/4" hex socket bit
5. Awl or similar tool 6. 5/16" hex socket bit
7. Audiovox Series 640/650 Video Module

* FOR USE IN VEHICLES EQUIPPED WITH FACTORY INSTALLED

ملخص المحتوى في الصفحة رقم 2

ITEM 2 1 1 2 2 3 - 6 4 4 5 1 6 1 7 Printed in the U.S.A. -

ملخص المحتوى في الصفحة رقم 3

1. . Caution: headliner. Cut only where indicated. 3 FIGURE 3 wiring or other componentry above Before cutting headliner material, check for ee Figure 3. to right in

ملخص المحتوى في الصفحة رقم 4

(2) two # 10 x 3/4" screws (item 1 pg 2) i n bottom 2). See Figure 4. NOTE: Additional assistance in mounting the overhead console in vehicle is advised - Down the B - pillar to the floor. Route the power extension, etc.) to the VCP location. See Figure 5. 4 FIGURE 5 instructions included with antenna.

ملخص المحتوى في الصفحة رقم 5

Make sure O.E.M. wire harness routes through - 32 Note: Do not overtighten Caution: 5 Failure to do so may cause damage to console or installed c

ملخص المحتوى في الصفحة رقم 6

10. area. 11. Note: Make sure that wires do not get pinched between bosses on video system and console. - 32 X 3/4" screws (item 4 pg 2) and (4) 8 Caution: Do not overtighten screws. rom (1) one # 8 x 1 1/4" screw (i tem 2 pg 2). Caution: Do not overtighten screws. 6 FIGURE 10 console. See Figure 10. of console are snapped firmly into