Audiovox 50-0300A-002 SERIES دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

FOR
50 - 0300A - 014 SERIES 1181282
50 - 0300A - 002 SERIES 1181284
FORD EXPLORER / MERCURY MOUNTAINEER w/ SUNROOF
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO




























ool
-
7. Test Light







-
Printed in the U.S.A
0039A INSTALLATION INSTRUCTION # 44
No

ملخص المحتوى في الصفحة رقم 2

1 - 1 6 2 4 2 SCREW, # 8 X 1 1/2" PWH 3 1 4 2 1 5 3 1 6 7 1 4 8 1 9 1 - Nov. 8, 1999 Printed in the U.S.A. 2 0039A IN

ملخص المحتوى في الصفحة رقم 3

1. Using the rear edge o Caution: Before cutting indicated. Make sure that the 7" cut is centere d left to right in vehicle. See Figure 1. 2. 3. 4. ground. See Figure 3. 5. 6. 3 FIGURE 3 Install O.E. dome light in original manner. Using a test light, tes

ملخص المحتوى في الصفحة رقم 4

7. Remove and retain (2) two O.E. screws from bracket. 8. rear of ket with center rivet on roof panel. 10. Secure rear of bracket using (2) two O.E. screws, 4 FIGURE 5 around sunroof opening. 11. Slide edge molding back into original po

ملخص المحتوى في الصفحة رقم 5

12. Inst - - pillar to the floor. Route the power lead to an ) to the VCP location. See two 6 - 32 x 3/4" screws (item 1 pg. 2) through the clips on front of mounting bracket. 1 1/ - 32 5 FIGURE 7 screws previously installed. See Figure 7. alignment is straight then tighten (2) two 6 2" screw (item 3 pg. 2). M

ملخص المحتوى في الصفحة رقم 6

Note : Make sure wires do not get pinched between video system and console. four 6 - Caution : Do not overtighten screws. Caution: Do not overtighten 20. 21. 22. 23. 6 FIGURE 9 Install cover pl