Tamarack Technologies TC1000 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

TCPG.3
TC1000
All Weather VENTILATOR
PRODUCT MANUAL & INSTALLATION GUIDE
Serial Number
Date of Purchase
Point of Purchase
The serial number is located on the shipping carton
and on a label affixed to the upper housing.
Unpacking your TC:
When you have unpacked your TC carefully you will find the following:
TC1000-T TC1000-H
One (1) TC1000-H All Weather Ventilator
One (1) TC1000-T All Weather Ventilator
One (1) Line Voltage Thermostat
The TC 1000 can be ins

ملخص المحتوى في الصفحة رقم 2

Installation Installing the TC1000 in a Wall You will need the following items: • Two pieces of 2x stock to match your existing framing • Saw to cut the hole in the wall • Hammer or Screw Gun to attach the blocking to the existing frame • Phillips head Screwdriver to attach the grille • Weather strip material • Low expansion Spray Foam sealant Add framing as shown to create a box of 12 1/2” x 27 3/4”. This box will act to hold the unit as well as creating a plenum for air movement. (Figure 1)

ملخص المحتوى في الصفحة رقم 3

Wiring Important - Wiring the TC is different than a normal ON/OFF fan. The TC damper is motorized and requires a constant source of power; power to open and power to close. The TC1000-T comes with a wall mounted, line voltage thermostat. This thermostat is surface mounted and should be positioned at eye level. The TC1000-H comes with a SPST wall switch that is mounted in a standard single gang electrical box. A 3-wire will need to be run between the control point and the TC regardless of the m

ملخص المحتوى في الصفحة رقم 4

Troubleshooting The most common installation error is caused by incorrect wiring. Be sure that each of the 3 wires in the TC1000 are connected individually. There is a 30 second delay after the control is activated and the damper opens before the fan motors start. Care All the motors in the TC are permanently sealed and do not require oiling. To keep dirt, dust and debris from the fans we recommend that you periodically remove the grille from within the living space and dust the fan blades.