ملخص المحتوى في الصفحة رقم 1
INSTRUCTION BOOKLET
COOKER HOOD
ZHC 95 ALU
ملخص المحتوى في الصفحة رقم 2
IMPORTANT SAFETY INFORMATION These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. • The ducting system for this appliance must not Installation be connected to any existing ventilation system • Any installation work must be undertaken by a which is being used for any ot
ملخص المحتوى في الصفحة رقم 3
CONTENTS For the User For the Installer Important Safety Information 2 Technical Information 10 Your Appliance 4 Electrical Connections 10 Operating Instructions 4 Installing the Cooker Hood 11 Maintenance and Cleaning 5 Something Not Working 6 Service and Spare Parts 6 Customer Care Department 6 Service Force Centres 7 Guarantee Conditions 9 3
ملخص المحتوى في الصفحة رقم 4
YOUR APPLIANCE OPERATING INSTRUCTIONS This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. To obtain the best performance it is advisable to switch on the hood a few minutes before you start cooking and leave it running for approximately 15 minutes after you finish cooking. Cooker Hood Controls V1 V2 V3 L L = Light switch V1 = On/Off switch and first motor speed V2 = Second speed V3 = Third speed 4
ملخص المحتوى في الصفحة رقم 5
MAINTENANCE AND CLEANING Before carrying out any The cooker hood must be kept maintenance or cleaning clean, a build up of grease or fat isolate the cooker hood from can be a fire hazard. the mains supply. Metal grease filters It is necessary to wash these filters at least every two months with warm water to which a little washing up liquid has been added. Their compact size means that they can be washed in the dishwasher. Replace the metal grease filters by removing the filter retaining clips (
ملخص المحتوى في الصفحة رقم 6
SOMETHING NOT WORKING If, having carried out these instructions carefully, your cooker hood fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start. Check that the hood is connected to the electricity supply. Check that the fan speed control is on. The cooker hood is not working effectively. Is the fan speed high enough for the task? Is the grease filter clean? Is the kitchen adequately vented to allow the entry of fresh air. If set up for re
ملخص المحتوى في الصفحة رقم 7
7
ملخص المحتوى في الصفحة رقم 8
8
ملخص المحتوى في الصفحة رقم 9
GUARANTEE CONDITIONS Standard Guarantee Conditions We, Zanussi, undertake that if within 24 months of the date of the purchase this Zanussi built-in appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option, repair or replace the same FREE OF ANY CHARGE for labour, materials and carriage on condition that: • The appliance has been correctly installed and used only on the electrical supply stated on the rating plate.
ملخص المحتوى في الصفحة رقم 10
INSTALLATION INSTRUCTIONS It is dangerous to alter the specifications or attempt to modify this product in any way. Technical Information DIMENSIONS Height (CANOPY) 100 mm Height (CHIMNEY) 450-850 mm Width (CANOPY) 898 mm Width (CHIMNEY) 200 - 270 mm Depth 507 mm Gross weight 24,5 kg Net weight 20 kg DUCTING OUTLET DIAMETER Ø120 mm ELECTRICAL SUPPLY: 220-240V (50Hz) POWER CONSUMPTION: 180 W FAN MOTOR: 140 W LAMP: (2x40W halogen spotlights) 40 W SUITABLE FOR INSTALLATION ABOVE: Electric Slot-In
ملخص المحتوى في الصفحة رقم 11
INSTALLING THE COOKER HOOD Please ensure that when the appliance is installed The cooker hood is made up of the following it is easily accessible to an engineer in the event components: of a breakdown. 1 No. Canopy C complete with controls and worktop All installation must comply with the local illumination. authorities requirements for the discharge 1 No.Telescopic chimney stack A complete with of exhaust air. ducting fan unit. 1 No. Flange 120mm F Incorrect installation may affect the safety 1
ملخص المحتوى في الصفحة رقم 12
INSTALLATION INSTRUCTIONS This appliance can be used in either a ducting or Clearance Heights filtering mode. Ducting – Cooking vapours and/or odours are passed The cooker hood is designed to be fitted over a straight outside (ceiling and/or wall) via a disposal cooking appliance at the clearance heights stated, duct, using the holes that are on the top and/or the providing the maximum output of the appliance back of the appliance. beneath does not exceed the maximums quoted in Filtering – Cooki
ملخص المحتوى في الصفحة رقم 13
INSTALLATION INSTRUCTIONS The versatility of the ducting fan unit on this hood enables it to be installed in one of four different ways: - Air outlet directed upwards (re-circulation fitting only). - Air outlet directed towards the wall (ducting fitting only). - Air outlet directed to the right or left (ducting fitting only).For correct installation of the hood, please proceed in the following stages: • Selection of the type of installation • Installation of the hood canopy C • Installation of t
ملخص المحتوى في الصفحة رقم 14
ø150 INSTALLATION INSTRUCTIONS Installation of the hood canopy C Drilling the wall a) Using the cardboard template provided, mark on the wall the centres of holes 1 for fixing of the hood canopy C .The centre of hole 2 for fixing the chimney, (a) air outlet directed upwards or towards the wall, (b-c) air outlet to the right or left hand side, must be marked at a distance X from the line between holes 1,obtained by measuring the extension Z of the chimney required for installation, plus 18 mm X =
ملخص المحتوى في الصفحة رقم 15
INSTALLATION INSTRUCTIONS Fitting the hood canopy C to the wall a) Remove the lower grill and the active charcoal filter if present (see paragraph on maintenance). b) Fit the support rod B using the two screws K (3,5x9,5)provided. B c) Hook the hood canopy C to the eye bolts O fixed in K holes 1. d) Adjust the support rod B so that it pushes against the wall. e) Adjusting position.There are two adjustable hooks at the rear of the hood, which can be used to adjust its A08_08 position as follows:
ملخص المحتوى في الصفحة رقم 16
INSTALLATION INSTRUCTIONS Drilling the shelves: S36_12 a) Using the cardboard template provided, and taking hole “B ”as a point of reference, drill the shelves along the central axis to allow the passage of the chimney. The chimney must be inserted into the shelves before it is fixed to the hood canopy C. b) When installing the re-circulation version with the air outlet directed upwards, if the fan unit is positioned below the line of shelves it will be necessary to drill a suitable hole in the
ملخص المحتوى في الصفحة رقم 17
INSTALLATION INSTRUCTIONS - Remove the plug from the upper part of the ducting fan unit, as it is not possible to insert the flange F with the plug in place. - Fit the flange F Ø120 or 150 mm,replace the plug. · Air outlet directed to the right or left hand side. - Remove the four screws fastening the plastic frame, as shown in figure . - Fit the ducting spigot R and replace the four screws removed as above. Fixing the chimney a) Loosen the screws M fixing the two parts of the chimney and pull t
ملخص المحتوى في الصفحة رقم 18
INSTALLATION INSTRUCTIONS Ducting or re-circulation fitting Ducting fitting. This is possible for all forms of installation: a) Connect the air outlet to the external ducting system. b) Remove the activated charcoal filter (if there is one)inside the hood canopy (see Maintenance). G Re-circulation fitting This is only possible with the air outlet directed upwards. Fit the venting grille G onto the air outlet.The activated charcoal filter should be fitted inside the hood canopy after connection
ملخص المحتوى في الصفحة رقم 19
ملخص المحتوى في الصفحة رقم 20
© Electrolux Household Appliances Limited 2001 4329478 03 - 010910
