Fetco Home Decor HWB-2000 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

HWB-2000 Series

FOOD EQUIPMENT TECHNOLOGIES COMPANY
640 Heathrow Drive • Lincolnshire • IL • 60069 • USA
3
Hot Water Dispensers
Phone: (800) 338-2699 • (847) 719-3000 • Fax: (847) 821-1178
E-mail: techsupport@fetco.com • Internet: http://www.fetco.com

Installation
(For Qualified Service Technicians Only)
Keys To A Successful Installation

Electrical: All FETCO dispensers require NEUTRAL. Ground is not an acceptable substitute. Installation
without neutral may cause damage

ملخص المحتوى في الصفحة رقم 2

• Vent tube connection is a 3/8 inch hose barb. • The end of the vent tube should be open to the air, not connected or submerged. 8. Power connection: • A fused disconnect switch or circuit breaker on the incoming power line must be conveniently located near the dispenser, and its location and markings known to the operators. • All dispensers require neutral. Damage to the dispenser may result if neutral is not present. • The body of the dispenser must be grounded to a suitable buildin

ملخص المحتوى في الصفحة رقم 3

HWB Series Programming Instructions The display shows the current tank temperature TEMPERATURE CONVERSION in ° Celsius when in normal operating mode. °C °F 82 180 83 181 Programming: 83 182 84 183 Temperature may be set in either Celsius or Fahrenheit. 84 184 85 185 1. Remove the top cover of the unit. 85 186 The control board is located on the left side near the front. 86 187 87 188 2. Turn the power switch ON. 87 189 88 190 8